Explore topic-wise MCQs in Chemical Engineering.

This section includes 401 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

201.

Though increased pressure has a retarding effect on cracking reaction, yet in actual process, a positive pressure of 10-15 kgf/cm2 is maintained during cracking mainly to

A. increase the yield of light distillates.
B. suppress coke formation.
C. enhance the octane number of gasoline.
D. reduce gum content in gasoline.
Answer» C. enhance the octane number of gasoline.
202.

Which parameter is used for the grading of paraffin waxes ?

A. Specific gravity
B. Melting point
C. Viscosity
D. Penetration number
Answer» D. Penetration number
203.

Thermofer catalytic cracking process is a __________ process.

A. fixed bed
B. moving bed
C. fluidised bed
D. non-catalytic
Answer» E.
204.

The average boiling point of aviation turbine fuel is closest to that of

A. lubricating oils
B. LPG
C. diesel
D. Kerosene
Answer» E.
205.

Smoke point of kerosene expresses its

A. burning characteristics.
B. luminosity characteristics.
C. aromatic content directly.
D. lamp wick wetting characteristics.
Answer» B. luminosity characteristics.
206.

Mercaptans is represented as (where R and R' are alkyl groups)

A. R-COOH
B. R-S-H
C. R-S-R
D. R-S-R'
Answer» C. R-S-R
207.

Which is the most effective catalyst used in catalytic cracking of petroleum products ?

A. Iron oxide
B. Nickel
C. Vanadium pentoxide
D. Zeolite
Answer» E.
208.

The characterisation factor of crude petroleum oil is around

A. 3
B. 11
C. 22
D. 28
Answer» C. 22
209.

Feedstock for the production of biodiesel is

A. herbal plants
B. used vegetable oils
C. LSHS
D. bagasse
Answer» C. LSHS
210.

Which of the following categories of gasoline has the highest lead susceptibility ?

A. Straight run gasoline
B. Platinum reformed gasoline
C. Catalytical cracked gasoline
D. Polymer gasoline
Answer» B. Platinum reformed gasoline
211.

Equal volumes of aniline and diesel oil when mixed at room temperature (during summer) was found to be completely mis-cible. It means that the aniline point of the diesel is __________ the room temperature.

A. more than
B. less than
C. same as
D. either more or less; depends on the room temperature
Answer» D. either more or less; depends on the room temperature
212.

Cetane number of high speed diesel must be ‚â•$

A. 30
B. 45
C. 75
D. 95
Answer» C. 75
213.

Water content in the crude oil as it comes out of oil well may be upto __________ percent.

A. 2
B. 5
C. 10
D. 25
Answer» E.
214.

Which of the following has maximum hydrogen/carbon ratio (by weight) ?

A. Naphtha
B. Gasoline
C. Diesel
D. Fuel oil
Answer» C. Diesel
215.

Isomerisation converts the __________ tot-paraffins.

A. paraffins
B. olefins
C. naphthenes
D. none of these
Answer» B. olefins
216.

Which of the following does not require preheating during storage in the storage tank as well as during atomisation through burners ?

A. PCM
B. Tar
C. Light diesel oil
D. Low viscosity furnace oil
Answer» D. Low viscosity furnace oil
217.

The general formula of naphthenes is

A. CnH2n + 2
B. CnH2n-6 (where, n ‚â• 6)
C. CnHn-4
D. same as that for olefins i.e. CnH2n
Answer» E.
218.

Penetration test determines the __________ of the grease.

A. stiffness
B. lubricating properties (e.g. oilness)
C. service temperature
D. variation in viscosity with temperature
Answer» B. lubricating properties (e.g. oilness)
219.

Flash point of a liquid petroleum fuel gives an idea about its

A. volatility.
B. explosion hazards characteristics.
C. nature of boiling point diagram.
D. all (a), (b) and (c)
Answer» E.
220.

Older crude petroleum

A. is light and better.
B. gives more distillates.
C. gives less tar.
D. all (a), (b) and (c).
Answer» C. gives less tar.
221.

Hydrocracking employs

A. high pressure & temperature.
B. low pressure & temperature.
C. high pressure and low temperature.
D. high temperature and low pressure.
Answer» B. low pressure & temperature.
222.

Petroleum is believed to have originated from __________ sources.

A. vegetable
B. animal
C. both (a) and (b)
D. neither (a) nor (b)
Answer» D. neither (a) nor (b)
223.

Liquefied petroleum Gas (LPG) used for the household cooking comprises mainly of

A. propane & butane
B. butane & ethane
C. methane & ethane
D. methane & carbon monoxide
Answer» B. butane & ethane
224.

Flash point of an oil is determined by the

A. Pensky Martens apparatus.
B. Ramsbottom apparatus.
C. Saybolt viscometer.
D. Conradson apparatus.
Answer» B. Ramsbottom apparatus.
225.

Ethyl mercaptan is added to the Doctor negative LPG for facilitating the detection of its leakage (by bad odour) to the extent of about __________ ppm.

A. 1
B. 50
C. 5000
D. 10000
Answer» C. 5000
226.

The condesate obtained on compression of wet natural gas is termed as

A. liquefied natural gasoline
B. natural gasoline
C. liquid natural gas
D. none of these
Answer» C. liquid natural gas
227.

Which is the most ideal feed stock for 'coking' process used for the manufacture of petroleum coke ?

A. Naphtha
B. Vacuum residue
C. Light gas oil
D. Diesel
Answer» C. Light gas oil
228.

Vacuum maintained in the vacuum distillation column in oil refinery is in the range of about __________ mm Hg absolute.

A. 1 to 5
B. 30 to 80
C. 250 to 350
D. 450 to 500
Answer» C. 250 to 350
229.

Olefins are

A. saturated hydrocarbons.
B. unsaturated cyclic compounds (hydrocarbons).
C. present in substantially good quantity in crude petroleum.
D. none of these.
Answer» E.
230.

Smoke volatility index is equal to smoke point plus

A. 0.42 x(% distilled at 204°C)
B. 5 mm
C. 0.84 x (% distilled at 204°C)
D. 10 mm. approximately
Answer» B. 5 mm
231.

Liquefied Petroleum Gas (LPG) is mainly a mixture of

A. propane & butane
B. methane & ethane
C. high boiling olefins
D. high boiling naphthenes
Answer» B. methane & ethane
232.

Most widely used solvent for dewaxing is

A. methyl-ethyl-ketone (MEK)
B. naphtha
C. petroleum ether
D. sodium plumbite
Answer» B. naphtha
233.

Which of the following theories of origin of petroleum does not explain the presence of nitrogen & sulphur compounds in crude oil?

A. Modern theory
B. Carbide theory
C. Engler theory
D. all (a), (b) and (c)
Answer» C. Engler theory
234.

__________ chloride present in crude petroleum as impurity is the most prolific producer of HCl during distillation.

A. Magnesium
B. Potassium
C. Calcium
D. Sodium
Answer» B. Potassium
235.

Solvent used in the Udex (glycol) extraction process for removal of light aromatics from cracked naphtha is

A. propane.
B. diethylene glycol.
C. aqueous solution (10% water) of diethylene glycol.
D. methyl ethyl ketone (MEK).
Answer» D. methyl ethyl ketone (MEK).
236.

Quinoline is a/an __________ compound.

A. sulphur
B. nitrogen
C. oxygen
D. none of these
Answer» C. oxygen
237.

The yield of straight run LPG from crude oil is about __________ weight percent.

A. 20-25
B. 1-1.5
C. 42278
D. 0.1-0.2
Answer» C. 42278
238.

Which one of the following processes aims at producing higher yield of gaseous unsaturated hydrocarbons and aromatics like benzene & toluene ?

A. Reforming
B. Pyrolysis
C. Alkylation
D. Hydrocracking
Answer» B. Pyrolysis
239.

Catalyst used in the catalytic polymerisation is

A. phosphoric acid on kieselghur
B. aluminium chloride
C. nickel
D. vanadium pentaoxide
Answer» B. aluminium chloride
240.

CnH2n is the general formula for

A. olefins
B. naphthenes
C. both (a) and (b)
D. neither (a) nor (b)
Answer» D. neither (a) nor (b)
241.

Petroleum coke is used mainly .in the

A. discoloration of yellow glycerine.
B. sugar refining.
C. manufacture of carbon electrode.
D. blast furnace for reduction of iron ore.
Answer» D. blast furnace for reduction of iron ore.
242.

Which of the following has the lowest cetane number ?

A. Aromatics
B. i-paraffins
C. Naphthene
D. Olefins
Answer» B. i-paraffins
243.

The terminology used for the bottom most product from the vacuum crude distillation unit is

A. residual crude
B. residuum
C. reduced crude
D. petrolatum
Answer» C. reduced crude
244.

Sulphuric acid treatment of petroleum products removes the __________ materials.

A. gum forming
B. color forming
C. asphaltic
D. all (a), (b) & (c)
Answer» E.
245.

Which of the following is a naphthene ?

A. Butene
B. Butadiene
C. Cyclohexane
D. Acetylene
Answer» D. Acetylene
246.

Concentration of H2SO4 catalyst in alkyla-tion is kept between 90-98%, because H2SO4 having concentration

A. less than 90% promotes polymerisation.
B. more than 98% promotes cracking.
C. both (a) and (b).
D. neither (a) nor (b).
Answer» D. neither (a) nor (b).
247.

Pick out the correct statement pertaining to catalytic cracking.

A. With increase in the reactor pressure, octane number of gasoline decreases.
B. With increase in the reactor temperature, gasoline yield decreases for a given conversion.
C. Percentage conversion increases with increase in the catalyst to oil ratio.
D. all (a), (b) and (c).
Answer» E.
248.

Higher vapour pressure of gasoline indicates

A. low flash point
B. high breathing loss
C. both (a) and (b)
D. neither (a) nor (b)
Answer» E.
249.

Extractor temperature is maintained at -20°C in Edeleanu process to reduce the __________ of kerosene.$

A. smoke point
B. paraffins
C. aromatics
D. naphthenes
Answer» C. aromatics
250.

Straight run petrol as compared to methyl/ethyl alcohol has

A. lower calorific value.
B. lower octane number.
C. higher specific gravity.
D. higher ignition temperature.
Answer» C. higher specific gravity.