

MCQOPTIONS
Saved Bookmarks
This section includes 194 Mcqs, each offering curated multiple-choice questions to sharpen your Electronics knowledge and support exam preparation. Choose a topic below to get started.
151. |
If the input to a comparator is a sine wave, the output is a: |
A. | ramp voltage |
B. | sine wave |
C. | rectangular wave |
D. | sawtooth wave |
Answer» D. sawtooth wave | |
152. |
This circuit is a bandpass filter. |
A. | 1 |
B. | |
Answer» B. | |
153. |
The input offset current equals the |
A. | average of two base currents |
B. | collector current divided by the current gain |
C. | difference between two base-emitter voltages |
D. | difference between two base currents |
Answer» E. | |
154. |
A portion of the output that provides circuit stabilization is considered to be: |
A. | negative feedback |
B. | distortion |
C. | open-loop |
D. | positive feedback |
Answer» B. distortion | |
155. |
The major difference between ground and virtual ground is that virtual ground is only a: |
A. | voltage reference |
B. | current reference |
C. | power reference |
D. | difference reference |
Answer» B. current reference | |
156. |
With a differential gain of 50,000 and a common-mode gain of 2, what is the common-mode rejection ratio? |
A. | –87.9 dB |
B. | –43.9 dB |
C. | 43.9 dB |
D. | 87.9 dB |
Answer» E. | |
157. |
The closed-loop voltage gain of an inverting amplifier equals: |
A. | the ratio of the input resistance to the feedback resistance |
B. | the open-loop voltage gain |
C. | the feedback resistance divided by the input resistance |
D. | the input resistance |
Answer» D. the input resistance | |
158. |
With negative feedback, the returning signal |
A. | is proportional to the output current |
B. | is proportional to the differential voltage gain |
C. | opposes the input signal |
D. | aids the input signal |
Answer» D. aids the input signal | |
159. |
The feedback resistor adds to the gain of an op-amp. |
A. | 1 |
B. | |
C. | 1 |
D. | |
Answer» C. 1 | |
160. |
Decreasing the gain in the given circuit could be achieved by |
A. | reducing the amplitude of the input voltage |
B. | increasing the value of the feedback resistor |
C. | increasing the value of the input resistor |
D. | removing the feedback resistor |
Answer» D. removing the feedback resistor | |
161. |
If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by two. |
A. | 1 |
B. | |
Answer» C. | |
162. |
Switching voltage regulators have ______ than linear regulators. |
A. | longer life |
B. | simpler circuitry |
C. | greater efficiency |
D. | lower cost |
Answer» D. lower cost | |
163. |
If a noninverting amplifier has an RIN of 1000 ohms and an RFB of 2.5 kilohms, what is the RIN voltage when 1.42 mV is applied to the correct input? |
A. | 3.5 mV |
B. | ground |
C. | 1.42 mV |
D. | 0.56 mV |
Answer» D. 0.56 mV | |
164. |
The input voltage must be ______ in the given circuit to obtain the given output voltage. |
A. | 343 mV |
B. | 400 mV |
C. | 480 mV |
D. | 600 mV |
Answer» C. 480 mV | |
165. |
What is the cutoff frequency of this low-pass filter? |
A. | 4.8 kHz |
B. | 3.8 kHz |
C. | 2.8 kHz |
D. | 1.8 kHz |
Answer» E. | |
166. |
In a PLL, to obtain lock, the signal frequency must: |
A. | come within the lock range |
B. | be less than the capture frequency |
C. | come within the capture range |
D. | be greater than the capture frequency |
Answer» D. be greater than the capture frequency | |
167. |
Op-amps used as high- and low-pass filter circuits employ which configuration? |
A. | noninverting |
B. | comparator |
C. | open-loop |
D. | inverting |
Answer» E. | |
168. |
A ______ is not a multivibrator. |
A. | one-shot |
B. | flip-flop |
C. | VCO |
D. | bistable |
Answer» B. flip-flop | |
169. |
A noninverting closed-loop op-amp circuit generally has a gain factor: |
A. | less than one |
B. | greater than one |
C. | of zero |
D. | equal to one |
Answer» C. of zero | |
170. |
What three subcircuits does a phase locked loop (PLL) consist of? |
A. | phase comparator, comparator, and VCO |
B. | phase comparator, bandpass filter, and VCO |
C. | phase comparator, bandpass filter, and demodulator |
D. | phase comparator, low-pass filter, and VCO |
Answer» E. | |
171. |
Current actually flows into or out of a virtual ground. |
A. | 1 |
B. | |
C. | 1 |
D. | |
Answer» C. 1 | |
172. |
What value of input resistance is needed in the given circuit to produce the given output voltage? |
A. | 50 |
B. | 4 k |
C. | 4.08 k |
D. | 5 k |
Answer» C. 4.08 k | |
173. |
If the gain of a closed-loop inverting amplifier is 3.9, with an input resistor value of 1.6 kilohms, what value of feedback resistor is necessary? |
A. | 6240 ohms |
B. | 2.4 kilohms |
C. | 410 ohms |
D. | 0.62 kilohms |
Answer» B. 2.4 kilohms | |
174. |
An op-amp circuit in which the output voltage is equal to the difference between the two input voltages is called a(n) _____ |
A. | integrator |
B. | differentiator |
C. | differential amplifier |
D. | voltage regulator |
Answer» D. voltage regulator | |
175. |
This circuit is a voltage follower. |
A. | 1 |
B. | |
Answer» C. | |
176. |
An output that is proportional to the addition of two or more inputs is from which type of amplifier? |
A. | differentiator |
B. | difference |
C. | summing |
D. | analog subtractor |
Answer» D. analog subtractor | |
177. |
The ratio between differential gain and common-mode gain is called: |
A. | amplitude |
B. | differential-mode rejection |
C. | common-mode rejection |
D. | phase |
Answer» D. phase | |
178. |
A circuit that uses an amplifier with passive filter elements is called a(n): |
A. | relaxation oscillator |
B. | signal generator |
C. | differential amplifier |
D. | active filter |
Answer» E. | |
179. |
All of the following are basic op-amp input modes of operation EXCEPT |
A. | inverting mode |
B. | common-mode |
C. | double-ended |
D. | single-ended |
Answer» B. common-mode | |
180. |
The common-mode voltage gain is |
A. | smaller than differential voltage gain |
B. | equal to voltage gain |
C. | greater than differential voltage gain |
D. | None of the above |
Answer» B. equal to voltage gain | |
181. |
A PLL can be used as a(n) ___________. |
A. | series voltage regulator |
B. | frequency multiplier |
C. | relaxation oscillator |
D. | Schmitt trigger |
Answer» C. relaxation oscillator | |
182. |
Another name for a unity gain amplifier is: |
A. | difference amplifier |
B. | comparator |
C. | single ended |
D. | voltage follower |
Answer» E. | |
183. |
The open-loop voltage gain (Aol) of an op-amp is the |
A. | external voltage gain the device is capable of |
B. | internal voltage gain the device is capable of |
C. | most controlled parameter |
D. | same as Acl |
Answer» C. most controlled parameter | |
184. |
How many leads does the TO-5 metal can package of an operational amplifier have? |
A. | 8, 10, or 12 |
B. | 6, 8, or 10 |
C. | 8 or 14 |
D. | 8 or 16 |
Answer» B. 6, 8, or 10 | |
185. |
If an op-amp has one input grounded and the other input has a signal feed to it, then it is operating as what? |
A. | Common-mode |
B. | Single-ended |
C. | Double-ended |
D. | Noninverting mode |
Answer» C. Double-ended | |
186. |
A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio of 3250. What would the output voltage be if the single-ended input voltage was 7 mV rms? |
A. | 1.4 mV rms |
B. | 650 mV rms |
C. | 4.55 V rms |
D. | 0.455 V rms |
Answer» D. 0.455 V rms | |
187. |
If ground is applied to the (+) terminal of an inverting op-amp, the (–) terminal will: |
A. | not need an input resistor |
B. | be virtual ground |
C. | have high reverse current |
D. | not invert the signal |
Answer» C. have high reverse current | |
188. |
Feedback is used in an open-loop operational amplifier circuit. |
A. | 1 |
B. | |
C. | 1 |
D. | |
Answer» C. 1 | |
189. |
What is the output waveform? |
A. | sine wave |
B. | square wave |
C. | sawtooth wave |
D. | triangle wave |
Answer» E. | |
190. |
In an open-loop op-amp circuit, whenever the inverting input (–) is negative relative to the noninverting input (+), the output will: |
A. | swing negative |
B. | close the loop |
C. | be balanced |
D. | swing positive |
Answer» E. | |
191. |
A series dissipative regulator is an example of a: |
A. | linear regulator |
B. | switching regulator |
C. | shunt regulator |
D. | dc-to-dc converter |
Answer» B. switching regulator | |
192. |
What is this circuit? |
A. | a low-pass filter |
B. | a high-pass filter |
C. | a bandpass filter |
D. | a band-stop filter |
Answer» E. | |
193. |
The voltage follower has a: |
A. | closed-loop voltage gain of unity |
B. | small open-loop voltage gain |
C. | closed-loop bandwidth of zero |
D. | large closed-loop output impedance |
Answer» B. small open-loop voltage gain | |
194. |
An ideal operational amplifier has |
A. | infinite output impedance |
B. | zero input impedance |
C. | infinite bandwidth |
D. | All of the above |
Answer» D. All of the above | |