Explore topic-wise MCQs in Electrical Engineering Questions.

This section includes 37 Mcqs, each offering curated multiple-choice questions to sharpen your Electrical Engineering Questions knowledge and support exam preparation. Choose a topic below to get started.

1.

When the modulating signal controls the frequency of the carrier, we get______________?

A. Phase modulation
B. Amplitude modulation
C. Frequency modulation
D. May be any one of the above
Answer» D. May be any one of the above
2.

The superhetrodyne principle provides selectivity at ______________stage?

A. RF
B. IF
C. audio
D. Before RF
Answer» C. audio
3.

The signal voltage induced in the aerial of a radio receiver is of the order of_____________?

A. mV
B. µV
C. V
D. None of the above
Answer» C. V
4.

The signal voltage induced in the aerial of a radio receiver is of the order of ________________?

A. mV
B. µV
C. V
D. None of the above
Answer» C. V
5.

The major advantage of FM over AM is__________________?

A. Reception is less noisy
B. Higher carrier frequency
C. Smaller bandwidth
D. Small frequency deviation
Answer» B. Higher carrier frequency
6.

The letters AVC stand for ________________?

A. Audio voltage control
B. Abrupt voltage control
C. Automatic volume control
D. Automatic voltage control
Answer» D. Automatic voltage control
7.

The IF is 455 kHz. If the radio receiver is tuned to 855 kHz, the local oscillator frequency is _______________?

A. 455 kHz
B. 1310 kHz
C. 1500 kHz
D. 1520 kHz
Answer» C. 1500 kHz
8.

The function of ferrite antenna is to_________________?

A. Reduce stray capacitance
B. Stabilise d.c. bias
C. Increase the Q of tuned circuit
D. Reduce noise
Answer» D. Reduce noise
9.

The diode detector in an AM radio receiver is usually found _____________?

A. Before the first RF stage
B. After the first RF stage
C. After several stages of amplification
D. None of the above
Answer» D. None of the above
10.

Overmodulation (amplitude) occurs when signal amplitude is _____________ carrier amplitude?

A. Equal to
B. Greater than
C. Less than
D. None of the above
Answer» C. Less than
11.

Over modulation results in ______________?

A. Weakening of the signal
B. Excessive carrier power
C. Distortion
D. None of the above
Answer» D. None of the above
12.

Most of the amplification in a superhetrodyne receiver occurs at ______________stage?

A. IF
B. RF amplifier
C. Audio amplifier
D. Detector
Answer» B. RF amplifier
13.

Modulation refers to a low-frequency signal controlling the ________________?

A. Amplitude of the carrier
B. Frequency of the carrier
C. Phase of the carrier
D. May be any of the above
Answer» E.
14.

Modulation is done in____________________

A. Transmitter
B. Radio receiver
C. Between transmitter and radio receiver
D. None of the above
Answer» B. Radio receiver
15.

Man made noise are______________ variations?

A. Amplitude
B. Frequency
C. Phase
D. Both phase and frequency
Answer» B. Frequency
16.

In TV transmission, sound signal is ______________modulated?

A. Amplitude
B. Frequency
C. Phase
D. None of the above
Answer» C. Phase
17.

In TV transmission, picture signal is ______________ modulated?

A. Frequency
B. Phase
C. Amplitude
D. None of the above
Answer» D. None of the above
18.

In the above question, what is the power in sidebands ?

A. 8 kW
B. 6 kW
C. 06 kW
D. 9 kW
Answer» D. 9 kW
19.

In superhetrodyne receiver, the input at mixer stage is________________?

A. IF and RF
B. RF and AF
C. IF and AF
D. RF and local oscillator signal
Answer» E.
20.

In radio transmission, the medium of transmission is ________________?

A. Space
B. An antenna
C. Cable
D. None of the above
Answer» B. An antenna
21.

In pakistan, ______________ modulation is used for radio transmission?

A. Frequency
B. Amplitude
C. Phase
D. None of the above
Answer» C. Phase
22.

In an AM wave useful power is carrier by ______________?

A. Carrier
B. Sidebands
C. Both sidebands and carrier
D. None of the above
Answer» C. Both sidebands and carrier
23.

In an AM wave, the majority of the power is in _____________?

A. Lower sideband
B. Upper sideband
C. Carrier
D. None of the above
Answer» D. None of the above
24.

In amplitude modulation, the _____________of carrier is varied according to the strength of the signal?

A. Amplitude
B. Frequency
C. Phase
D. None of the above
Answer» B. Frequency
25.

In amplitude modulation, bandwidth is ____________ the audio signal frequency?

A. Thrice
B. Four times
C. Twice
D. None of the above
Answer» D. None of the above
26.

In a TRF radio receiver, the RF and detection stages are tuned to______________?

A. Radio frequency
B. IF
C. Audio frequency
D. None of the above
Answer» B. IF
27.

In a transmitter ____________oscillator is used?

A. Hartley
B. RC phase-shift
C. Wien-bridge
D. Crystal
Answer» E.
28.

In a superhetrodyne receiver, the difference frequency is chosen as the IF rather than the sum frequency because _________________?

A. The difference frequency is closer to oscillator frequency
B. Lower frequencies are easier to amplify
C. Only the difference frequency can be modulated
D. None of the above
Answer» C. Only the difference frequency can be modulated
29.

In a radio receiver, we generally use ………….. oscillator as a local oscillator

A. Crystal
B. Wien-bridge
C. Phase-shift
D. Hartley
Answer» E.
30.

In a radio receiver, noise is generally developed at _______________?

A. IF stage
B. Receiving antenna
C. Audio stage
D. RF stage
Answer» E.
31.

If modulation is 100% then signal amplitude is ____________arrier amplitude?

A. Equal to
B. Greater than
C. Less than
D. None of the above
Answer» B. Greater than
32.

If level of modulation is increased ______________ power is increased?

A. Carrier
B. Sideband
C. Carrier as well as sideband
D. None of the above
Answer» C. Carrier as well as sideband
33.

If a radio receiver amplifies all the signal frequencies equally well, it is said to have high ________________?

A. Sensitivity
B. Selectivity
C. Distortion
D. Fidelity
Answer» E.
34.

Demodulation is done in ________________?

A. Receiving antenna
B. Transmitter
C. Radio receiver
D. Transmitting antenna
Answer» D. Transmitting antenna
35.

At 100% modulation, the power in each sideband is _____________ of that of carrier?

A. 50%
B. 40%
C. 60%
D. 25%
Answer» E.
36.

As the modulation level is increased, the carrier power__________________?

A. Is increased
B. Remains the same
C. Is decreased
D. None of the above
Answer» C. Is decreased
37.

A high Q tuned circuit will permit an amplifier to have high __________________?

A. Fidelity
B. Frequency range
C. Sensitivity
D. Selectivity
Answer» E.