MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Machine Drawing knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
The type of the dimension of the given object in the below figure is __________ |
| A. | Basic size equal to 50.00 and tolerance +.05 and -.05 |
| B. | Limits where maximum limit is 50.05 and minimum limit is 49.05 |
| C. | Basic size with the tolerance |
| D. | Dimension of rectangle having 50.05 and 49.98 |
| Answer» C. Basic size with the tolerance | |
| 2. |
What is the type of the tolerance provided here and dimension of the given object in the figure below? |
| A. | Equal bilateral and maximum size of 50.05 |
| B. | Equal bilateral and minimum size of 50.05 |
| C. | Equal bilateral and minimum size of 49.95, maximum size of 50.05 |
| D. | Equal unilateral and minimum size of 49.05, maximum size of 50.05 |
| Answer» D. Equal unilateral and minimum size of 49.05, maximum size of 50.05 | |
| 3. |
What is the minimum dimension of the given shaft up to which it can be machined? |
| A. | 35.79 |
| B. | 35.49 |
| C. | 35.99 |
| D. | 35.29 |
| Answer» C. 35.99 | |
| 4. |
For the below given figure, the dimension of A will be __________ |
| A. | 40.2 |
| B. | 40.60 |
| C. | 40.00 |
| D. | 39.7 |
| Answer» D. 39.7 | |
| 5. |
A component is given the dimension as shown below. The type of tolerance is __________ |
| A. | Symmetrical |
| B. | Unilateral |
| C. | Unequal bilateral |
| D. | Equal bilateral |
| Answer» D. Equal bilateral | |
| 6. |
Cost of manufacturing is ____________ |
| A. | Inversely proportional to the amount of tolerance specified |
| B. | Directly proportional to the amount of tolerance specified |
| C. | Does not depends on tolerance specified |
| D. | Does depends non-linearly |
| Answer» B. Directly proportional to the amount of tolerance specified | |
| 7. |
Tolerance is ___________ |
| A. | Difference between the basic size and maximum limit |
| B. | Difference Between the minimum and basic size |
| C. | Difference between the maximum and minimum limit size |
| D. | The maximum size of the component allowed |
| Answer» D. The maximum size of the component allowed | |
| 8. |
What is the actual size? |
| A. | Dimension of a component on paper |
| B. | Dimension of the component manufactured |
| C. | Size of the component as per theory of failure |
| D. | Size of the object with all the tolerances |
| Answer» C. Size of the component as per theory of failure | |
| 9. |
What is the basic size? |
| A. | Size calculated by the design engineer to withstand the stress coming in component |
| B. | Size exactly of that of given object under consideration |
| C. | Size of the object with given deviations |
| D. | Size with which a job come out of the shop |
| Answer» B. Size exactly of that of given object under consideration | |
| 10. |
The system in which variation in size is accepted is termed as ___________ |
| A. | Limit system |
| B. | Tolerance System |
| C. | Limit and tolerance system |
| D. | Variable system |
| Answer» B. Tolerance System | |