Explore topic-wise MCQs in Chemical Engineering.

This section includes 854 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

501.

The mass transfer co-efficient for a solid sphere of radius 'a' dissolving in a large volume of quiescent liquid, in which D is the diffusivity of solute, is

A. D/a
B. D/2a
C. proportional to D
D. dependent on the Reynolds number
Answer» E.
502.

In a liquid-liquid extraction, 10 kg of a solution containing 2 kg of solute C and 8 kg of solvent A is brought into contact with 10 kg of solvent B. Solvent A and B are completely immiscible in each other whereas solute C is soluble in both the solvents. The extraction process attains equilibrium. The equilibrium relationship between the two phases is Y* = 0.9X, where Y* is the kg of C/kg of B and X is kg of C/kg of A. Choose the correct answer.

A. The entire amount of C is transferred to solvent B.
B. Less than 2 kg but more than 1 kg of C is transferred to solvent B.
C. Less than 1 kg of C is transferred to B.
D. No amount of C is tranferred to B.
Answer» B. Less than 2 kg but more than 1 kg of C is transferred to solvent B.
503.

Leaching of coarse solid lumps is also termed as

A. decoction
B. dissolution
C. percolation
D. agitation and settling
Answer» D. agitation and settling
504.

In a packed tower, the value of HETP equals HTUOG, when the equilibrium and the operating lines are (where, HETP = height equivalant to a theoretical plate HTUOG = overall gas phase height of a transfer unit)

A. straight
B. parallel
C. both (a) & (b)
D. neither (a) nor (b)
Answer» D. neither (a) nor (b)
505.

As the reflux ratio decreases, the

A. separation becomes more efficient.
B. number of plates increases.
C. column diameter increases.
D. none of these.
Answer» C. column diameter increases.
506.

For absorbing a sparingly soluble gas in a liquid

A. gas side mass transfer co-efficient should be increased.
B. liquid side mass transfer co-efficient should be increased.
C. liquid side mass transfer co-efficient should be decreased.
D. mass transfer co-efficient must be kept constant.
Answer» C. liquid side mass transfer co-efficient should be decreased.
507.

During drying operation, it is easier to remove the __________ moisture.

A. equilibrium
B. critical
C. unbound
D. bound
Answer» D. bound
508.

All moisture in a non-hygroscopic material is the __________ moisture.

A. free
B. equilibrium
C. unbound
D. bound
Answer» D. bound
509.

Surface renewal model of mass transfer was enunciated by

A. Toor and Marchello
B. Fick
C. Danckwerts
D. Stefan
Answer» D. Stefan
510.

The operation involved when the soluble material is largely on the surface of an insoluble solid and is merely washed off by the solvent is called

A. decoction
B. percolation
C. elutriation or elution
D. none of these
Answer» D. none of these
511.

Danckwerts developed the __________ theory.

A. penetration
B. surface renewal
C. film
D. none of these
Answer» C. film
512.

Which of the following remains constant during evaporative cooling process with recirculated water supply ?

A. Relative humidity
B. Partial pressure of vapour
C. Wet bulb temperature
D. None of these
Answer» D. None of these
513.

Ion exchange process is similar to

A. absorption
B. adsorption
C. extraction
D. leaching
Answer» C. extraction
514.

When a multistage tray tower uses a minimum reflux ratio, it implies

A. infinite trays and maximum reboiler heat load.
B. infinite trays and minimum reboiler heat load.
C. minimum trays and minimum reboiler heat load.
D. minimum trays and maximum reboiler heat load
Answer» B. infinite trays and minimum reboiler heat load.
515.

With increase in gas rate, the number of transfer units, NtoG, for a fixed degree of absorption by a fixed amount of solvent

A. increases
B. decreases
C. decreases linearly
D. remains unaffected
Answer» B. decreases
516.

Only small amount of evaporation of water produces large cooling effects because of its

A. large latent heat
B. low viscosity
C. small latent heat
D. none of these
Answer» B. low viscosity
517.

Sticky material can be dried in a __________ dryer.

A. tray
B. rotary
C. fluidised bed
D. none of these
Answer» B. rotary
518.

'ADDUCTS' and 'CLATHRATES' are used in case of

A. extractive distillation.
B. crystallisation.
C. absorption.
D. none of these.
Answer» C. absorption.
519.

In a forced draft cooling tower, water is cooled from 95 to 80°F by exposure to air with a wet bulb temperature of 70°F. In this case, the$

A. range is 15°F.
B. approach is 10°F.
C. both (a) & (b).
D. neither (a) nor (b).
Answer» D. neither (a) nor (b).
520.

In a counter-current liquid extractor

A. both liquids flow at fixed rate.
B. both liquids can have any desired flow rate.
C. only one of the liquids may be pumped at any desired rate.
D. liquid's flow rate depends upon the temperature and pressure.
Answer» D. liquid's flow rate depends upon the temperature and pressure.
521.

In case of absorption, both the operating and equilibrium lines will be straight for

A. isothermal operation.
B. dilute solutions.
C. dilute solutions and isothermal operation.
D. none of these.
Answer» D. none of these.
522.

Absorption accompanied by heat evolution results in

A. increased capacity of the absorber.
B. increase in equilibrium solubility.
C. decrease in equilibrium solubility.
D. none of these.
Answer» D. none of these.
523.

Moisture in a substance exerting an equilibrium vapour pressure less than that of pure liquid at the same temperature is called the __________ moisture.

A. bound
B. unbound
C. critical
D. none of these
Answer» B. unbound
524.

Desulphurisation of petrol is done in a

A. Bollman extractor
B. rotating disc extractor
C. packed extraction column
D. plate type extraction column
Answer» C. packed extraction column
525.

Diffusion co-efficient generally depends upon the temperature, pressure & the nature of the components of the system. Its dimension is not the same as that of the

A. mass transfer co-efficient.
B. thermal diffusivity.
C. kinematic viscosity.
D. volumetric diffusivity.
Answer» B. thermal diffusivity.
526.

At what value of reflux ratio, number of theoretical plates in a distillation column is minimum ?

A. 0
B. 1
C. ‚àû
D. < 1
Answer» D. < 1
527.

At the boiling point of the liquid at the prevailing pressure, the saturated absolute humidity becomes

A. 1
B. 0
C. ‚àû
D. none of these
Answer» D. none of these
528.

Extraction of pencillin employs a __________ extraction coloumn.

A. centrifugal
B. packed
C. plate
D. None of these.
Answer» B. packed
529.

For absorbers, high pressure drop results in

A. increased efficiency.
B. decreased efficiency.
C. high operating cost.
D. better gas liquid contact.
Answer» D. better gas liquid contact.
530.

The Reynolds number of the liquid was increased 100 fold for a laminar falling film used for gas-liquid contacting. Assuming penetrating theory is applicable, the fold increase in the mass transfer co-efficient (Kc) for the same sytem is

A. 100
B. 10
C. 5
D. 1
Answer» C. 5
531.

Under conditions of flooding in packed tower, the gas pressure drop

A. decreases rapidly
B. increases rapidly
C. remains constant
D. is maximum
Answer» E.
532.

Decoction refers to the use of solvent

A. at ambient temperature
B. at its boiling point
C. in its vapor form
D. none of these
Answer» C. in its vapor form
533.

Which of the following processes is not an example of adsorption applied to gaseous separations ?

A. Recovery of valuable solvent vapors from dilute mixture with air and other gases.
B. Dehumidification of air and gas.
C. Removal of objectionable odour and impurities from industrial gases.
D. Decolouration of yellow glycerene.
Answer» E.
534.

A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))

A. M(Xo - XF)
B. M(Xo/XF)
C. M ln(Xo/XF)
D. MXo ln(Xo/XF)
Answer» E.
535.

Binary distillation involves the mass transfer by __________ at the gas-liquid interface.

A. unidirectional diffusion from liquid to gas phase
B. unidirectional diffusion from gas to liquid phase
C. either 'a' or 'b'
D. a counter diffusion at an almost equal molar rate
Answer» E.
536.

The suitable evaporator for concentration of foaming liquids is a __________ evaporator.

A. long tube
B. short tube
C. vacuum
D. falling film
Answer» B. short tube
537.

The temperature of water cooled in cooling tower is always __________ temperature of entering air.

A. more than the wet bulb
B. less than the wet bulb
C. equal to the wet bulb
D. equal to the dry bulb
Answer» B. less than the wet bulb
538.

In case of constant underflow extraction operation, the __________ at all solute concentration.

A. solids are drained to the same extent
B. ratio of the insoluble to solution is constant
C. both(a) & (b)
D. neither (a) nor (b)
Answer» D. neither (a) nor (b)
539.

Unit operation involved in the prilling of urea is

A. evaporation
B. drying
C. crystallisation
D. both (b) and (c)
Answer» E.
540.

In saturated gas, the

A. vapour is in equilibrium with the liquid at the gas temperature.
B. vapour is in equilibrium with the liquid at the room temperature.
C. partial pressure of vapour equals the vapour pressure of the liquid at room temperature.
D. none of these.
Answer» B. vapour is in equilibrium with the liquid at the room temperature.
541.

In case of liquid-liquid binary diffusion, diffusivity of one constituent into another is not dependent on the

A. temperature and pressure
B. concentration
C. nature of the constituents
D. none of these
Answer» E.
542.

The relation among various mass transfer co-efficients (M.T.C) for ideal gases is given by (where, Kc & Km are M.T.C. for equimolar counter diffusion with concentration & mole fraction respectively as the driving force. and, Kp = M.T.C. for diffusion of a gas through a stagnant inert gas with pressure as driving force.)

A. Kc = Kp = Km
B. Kc = Kp/RT = Km . RT/P
C. Kc = Kp . RT = Km . RT/p
D. none of these
Answer» D. none of these
543.

Laboratory determination of the dif-fusivity of vapor is done by __________ method.

A. wetted wall column
B. Gilliland's
C. Winkel mann's
D. Wike's
Answer» D. Wike's
544.

For a binary mixture with low relative volatility, continuous rectification to get pure products will require

A. low reflux ratio
B. less number of trays
C. small cross-section column
D. high reflux ratio
Answer» E.
545.

Plate efficiency in a distillation column is reduced due to the __________ of liquid.

A. entrainment
B. foaming
C. weeping & dumping
D. all (a), (b) & (c)
Answer» E.
546.

Prandtl number for water at 20°C is about$

A. 7
B. 70
C. 0.7
D. 150
Answer» B. 70
547.

Relative volatility varies with the concentration of component for an ideal solution. The relative volatity of a binary mixture may be defined as the ratio of vapor pressure of component 'A' to that of component 'B', when

A. only vapor phase follows Raoult's law.
B. only liquid phase obeys Dalton's law.
C. liquid phase obeys Dalton's law and vapor phase obeys Raoult's law.
D. Vapor phase obeys Dalton's law and liquid phase obeys Raoult's law.
Answer» E.
548.

When the psychometric ratio is __________ then the adiabatic saturation temperature and wet bulb temperature becomes equal.

A. 1
B. < 1
C. > 1
D. ‚àû
Answer» B. < 1
549.

Which of the following is not fixed by the process requirements, in the design of absorbers ?

A. Flow rate of the entering gas.
B. Composition of the entering liquid.
C. Terminal concentrations of gas stream.
D. None of these.
Answer» E.
550.

In case of an unsaturated mixture of gas and vapor, the percentage saturation is __________ its relative saturation.

A. lower than
B. higher than
C. equal to
D. either (a) or (b), depends on the mixture composition
Answer» B. higher than