Explore topic-wise MCQs in Spanning Tree Protocol.

This section includes 4 Mcqs, each offering curated multiple-choice questions to sharpen your Spanning Tree Protocol knowledge and support exam preparation. Choose a topic below to get started.

1.

What are the distinct functions of layer 2 switching that increase available bandwidth on the network?

1.Address learning

2.Routing

3.Forwarding and filtering

4.Creating network loops

5.Loop avoidance

6.IP addressing
A. 1, 3 and 5
B. 2, 4 and 6
C. 2 and 6
D. 3 and 5
Answer» B. 2, 4 and 6
Discussion
2.

What is the result of segmenting a network with a bridge (switch)?

1.It increases the number of collision domains.

2.It decreases the number of collision domains.

3.It increases the number of broadcast domains.

4.It decreases the number of broadcast domains.

5.It makes smaller collision domains.

6.It makes larger collision domains.
A. 1 and 5
B. 2, 3 and 5
C. 3, 4 and 6
D. 1, 3 and 6
Answer» B. 2, 3 and 5
Discussion
3.

You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?

1.Switch(config-if)# ip access-group 10

2.Switch(config-if)# switchport port-security maximum 1

3.Switch(config)# access-list 10 permit ip host 1

4.Switch(config-if)# switchport port-security violation shutdown

5.Switch(config)# mac-address-table secure
A. 1 and 3
B. 2 and 4
C. 2, 3 and 5
D. 4 and 5
Answer» C. 2, 3 and 5
Discussion
4.

Layer 2 switching provides which of the following?

1.Hardware-based bridging (ASIC)

2.Wire speed

3.Low latency

4.Low cost
A. 1 and 3
B. 2 and 4
C. 1, 2 and 4
D. All of the above
Answer» E.
Discussion