MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 4 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Engineering Questions & Answers Tool Geometery and Nomenclature-1 knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following will give large friction during chip flow? |
| A. | Positive back rake angle tool |
| B. | Negative back rake angle tool |
| C. | Zero back rake angle tool |
| D. | Small lip angle tool |
| Answer» C. Zero back rake angle tool | |
| 2. |
Which of the following will give better chip flow? |
| A. | Positive back rake angle tool |
| B. | Negative back rake angle tool |
| C. | Zero back rake angle tool |
| D. | None of the mentioned |
| Answer» B. Negative back rake angle tool | |
| 3. |
For large negative back rake angle, tool will be |
| A. | Weaker |
| B. | Stronger |
| C. | Smoother |
| D. | Harder |
| Answer» C. Smoother | |
| 4. |
Angle between end cutting edge and axis of tool is known as: |
| A. | Side rake angle |
| B. | Side relief angle |
| C. | End cutting edge angle |
| D. | Back rake angle |
| Answer» D. Back rake angle | |