Explore topic-wise MCQs in Testing Subject.

This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.

1.

A metering mechanism commonly used in bullock drawn planter in country is

A. Cup feed mechanism
B. Cell fed type mechanism
C. Brush feed mechanism
D. None of these
Answer» D. None of these
2.

In CFTRI method, the water is heated to a temperature of

A. 70?C
B. 75?C
C. 80?C
D. 85?C
Answer» E.
3.

The tension of water at saturation capacity is almost

A. 0
B. 1
C. 10
D. 20
Answer» B. 1
4.

Percentage of husk in paddy is about

A. 15-18 per cent
B. 18-22 per cent
C. 20-24 per cent
D. 25-30 per cent
Answer» C. 20-24 per cent
5.

The percentage of nitrogen in gobar gas manure is

A. 1.50%
B. 2.00%
C. 4.50%
D. 8%
Answer» C. 4.50%
6.

The recommended belt speed for grain conveying ranges is

A. 2.3-2.5 m/s
B. 2.5-2.8 m/s
C. 30-3.5 m/s
D. 3.5-4.5 m/s
Answer» C. 30-3.5 m/s
7.

The porosity of sandy soil usually ranges from

A. 30 to 35%
B. 35 to 50%
C. 40 to 60%
D. 50 to 60%
Answer» C. 40 to 60%
8.

Bevel gears transmit power between two shafts are

A. Intersecting axis
B. Parallel shaft
C. Inline shaft
D. All are correct
Answer» B. Parallel shaft
9.

The capacity of hammer mill depends upon the

A. Feed rate
B. Hammer speed
C. Size of sieve
D. All are correct
Answer» D. All are correct
10.

The dry process of biomass digestion involves

A. Pyrolysis and liquenfication
B. Anaerobic digestion and fermentation
C. Fermentation and pyrolysis
D. All are correct
Answer» B. Anaerobic digestion and fermentation
11.

Accumulator is used in

A. Jerk pump system
B. Unit injector system
C. Common rail system
D. Distributor system
Answer» D. Distributor system
12.

A pump, which supplies the fuel to different cylinder or multi cylinder engine is

A. Centrifugal pump
B. Oil pump
C. Fuel injection pump
D. None of these
Answer» D. None of these
13.

The capacity of biogas plant varies from

A. 2.0-2.75 m3
B. 10-50 m3
C. 2-150 m3
D. 5-200 m3
Answer» D. 5-200 m3
14.

A hyetograph is plot of

A. Rainfall intensity versus time
B. Rainfall depth versus duration
C. Cumulative rainfall versus time
D. Discharge versus time
Answer» B. Rainfall depth versus duration
15.

Vertical rotor metering device is used for

A. Bed planting
B. Precision planting
C. Furrow planting
D. Ridge planting
Answer» C. Furrow planting
16.

A situation where more than 25% decrease in precipitation from the normal over an area is called

A. Hydrological drought
B. Meteorological drought
C. Agricultural drought
D. None of these
Answer» C. Agricultural drought
17.

An undisturbed soil surface of furrow

A. Furrow slice
B. Furrow wall
C. Furrow crown
D. All are correct
Answer» C. Furrow crown
18.

Contour blinds are recommended for the areas of

A. Low rainfall
B. Medium rainfall
C. High rainfall
D. None of these
Answer» B. Medium rainfall
19.

Evapotranspiration is confined

A. Day time
B. Night time
C. Both (a) and (b)
D. None of these
Answer» B. Night time
20.

Specific gravity of a fully discharged battery is

A. 1.50 or less
B. 1.20 or more
C. Both (a) & (b)
D. None of these
Answer» B. 1.20 or more
21.

Wave energy is associated with

A. Sun
B. Ocean
C. Wind
D. All are correct
Answer» C. Wind
22.

The hoiling temperature of methanol is

A. 45?C
B. 65?C
C. 47?C
D. 85?C
Answer» C. 47?C
23.

To plough a one-hectare land with 15 cm width country plough, a man has to walk

A. 52 km
B. 60 km
C. 66 km
D. 72 km
Answer» D. 72 km
24.

The expected life of stationary engine is

A. 10,000 hrs
B. 12,000 hrs
C. 15,000 hrs
D. 20,000 hrs
Answer» B. 12,000 hrs
25.

Rietz mill suitable for grinding material below is of

A. 15 micron size
B. 20 micron size
C. 25 micron size
D. 30 micron size
Answer» B. 20 micron size
26.

The land holding of large farmer is

A. Less than 4 ha land
B. Between 4 and 10 ha
C. Less than 10 ha
D. More than 10 ha
Answer» E.
27.

Ridge planting is most suitable for

A. Low rainfall areas
B. Average rainfall areas
C. High rainfall areas
D. None of these
Answer» D. None of these
28.

The unit of intrinsic permeability is

A. Cm/day
B. m/day
C. Cm2
D. Cm3
Answer» D. Cm3
29.

Spattering of small soil particles, caused by raindrop impact on wet soil is called as

A. Inter rill erosion
B. Rill erosion
C. Chemical erosion
D. All are correct
Answer» B. Rill erosion
30.

The height of spray for rotary type hand sprayer for effective spraying is

A. 1 metre
B. 2 metres
C. 3 metres
D. 4 metres
Answer» D. 4 metres
31.

Hot plugs used in tractor is operated by

A. Light load
B. Heavy load
C. No load
D. None of these
Answer» B. Heavy load
32.

For impact cutting, dual edge signle element blade requires a volocity of

A. 10 m/sec
B. 20 m/sec
C. 30 m/sec
D. 40 m/sec
Answer» E.
33.

Which soil is more resistant to erosion?

A. Sandy soil
B. Cay soil
C. Loamy soil
D. All are correct
Answer» C. Loamy soil
34.

Wind erosion is more in

A. Cohesive soils
B. Non-cohesive soils
C. Rocky soils
D. None of these
Answer» C. Rocky soils
35.

The API gravity of water is

A. 8
B. 10
C. 15
D. 20
Answer» C. 15
36.

The most relevant flow to cause soil erosion is

A. Laminar flow
B. Uniform flow
C. Turbulent flow
D. All are correct
Answer» D. All are correct
37.

Soil erosion involves the detachment and transportation of

A. Insoluble soil materials
B. Soluble soil mterials
C. Both (a) and (b)
D. None of these
Answer» B. Soluble soil mterials
38.

A soil consistency in the characteristics of the soil at various moisture content when influenced by physical force is

A. Cohesion
B. Adhesion
C. Both (a) and (b)
D. None of these
Answer» D. None of these
39.

A noise level for six hours of working is

A. 80 dB
B. 85 dB
C. 90 dB
D. 92 dB
Answer» E.
40.

To particle size of gravel according to USWA is

A. 0.5 to 1 mm
B. 1 to 2 mm
C. <2 mm
D. >2 mm
Answer» E.
41.

The calorific value of gasoline is

A. 45 MJ/kg
B. 45 Kj/kg
C. 45 J/kg
D. None of these
Answer» B. 45 Kj/kg
42.

In horizontal plate planter, the percentage is

A. Less than 100
B. 100
C. More than 100
D. None of these
Answer» D. None of these
43.

Pressure due to radiator cap

A. Raises boiling temperature
B. Reduces boiling temperature
C. Cools the water
D. None of these
Answer» B. Reduces boiling temperature
44.

A two-way plough eliminates

A. Back Furrow
B. Dead furrow
C. Both (a) & (b)
D. None of these
Answer» D. None of these
45.

Two-stroke engine are

A. High speed engine
B. Low speed engine
C. Medium speed engine
D. All are correct
Answer» B. Low speed engine
46.

The injector and fuel pump are the heart of

A. Diesel
B. Steam engine
C. Petrol engine
D. Gas engine
Answer» B. Steam engine
47.

The temperature at which flame persists approximately for 5 seconds is

A. Pour point
B. Flash point
C. Fire point
D. All are correct
Answer» D. All are correct
48.

The average force that a bullock can exert

A. 1/5th of their body weight
B. 1/10th of their body weight
C. 1/20th of their body weight
D. 1/25th of their body weight
Answer» C. 1/20th of their body weight
49.

Molecular formula of diesel is

A. C11H15
B. C11 H16
C. C12 H15
D. C11H14
Answer» C. C12 H15
50.

Flame gun is used for killing the

A. Insects
B. Pests
C. Weeds
D. All are correct
Answer» D. All are correct