MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
In forced air-dring method the moisture moves from |
| A. | Grain to air |
| B. | Centre to grain surface |
| C. | Air to grain |
| D. | All are correct |
| Answer» B. Centre to grain surface | |
| 2. |
Useful life of stationary engine is |
| A. | 8 years |
| B. | 10 years |
| C. | 12 years |
| D. | 15 years |
| Answer» C. 12 years | |
| 3. |
Specific gravity measured by an instrument is |
| A. | Hydrometer |
| B. | Hygrometer |
| C. | Thermometer |
| D. | All are correct |
| Answer» B. Hygrometer | |
| 4. |
The optimum engine temperature is about |
| A. | 60 deg. |
| B. | 82 deg. |
| C. | 100 deg. |
| D. | 120 deg. |
| Answer» C. 100 deg. | |
| 5. |
Graded terraces are used in the areas of |
| A. | Medium to high rainfall |
| B. | High rainfall, only |
| C. | Medium rainfall, only |
| D. | None of these |
| Answer» B. High rainfall, only | |
| 6. |
A conventional pitman drive mower has crank speed of |
| A. | 750-900 rpm |
| B. | 850-1100 rpm |
| C. | 850-1250 rpm |
| D. | 900-1200 rpm |
| Answer» C. 850-1250 rpm | |
| 7. |
The cutting height of reaper binder from ground is about |
| A. | 5 cm |
| B. | 10 cm |
| C. | 15 cm |
| D. | 20 cm |
| Answer» C. 15 cm | |
| 8. |
The ratio of output power to input power for a traction device is called |
| A. | Mechanical efficiency |
| B. | Thermal efficiency |
| C. | Tractive efficiency |
| D. | None of these |
| Answer» D. None of these | |
| 9. |
Land plane is ideally suited for |
| A. | Land leveling |
| B. | Earth moving |
| C. | Final grading |
| D. | Top finishing |
| Answer» E. | |
| 10. |
The process of separation of grain from a mixture of grain and chaff is |
| A. | Cleaning |
| B. | Winnowing |
| C. | Separation |
| D. | Grading |
| Answer» C. Separation | |
| 11. |
The metering mechanism used in potato planter is |
| A. | Fluted roller |
| B. | Brush feed type |
| C. | Picker wheel type |
| D. | Cell feed type |
| Answer» D. Cell feed type | |
| 12. |
Share of mould board plough is made of |
| A. | Cast iron |
| B. | Mild steel |
| C. | C-1095 sold steel |
| D. | All are correct |
| Answer» D. All are correct | |
| 13. |
The fuel injection pressure of CI engine ranges from |
| A. | 10 to 45 kg/cm2 |
| B. | 50 to 120 kg/cm2 |
| C. | 120 to 175 kg/cm2 |
| D. | 100 to 300 kg/cm2 |
| Answer» D. 100 to 300 kg/cm2 | |
| 14. |
Tank capacity of compression sprayer is |
| A. | 10 litres |
| B. | 12 litres |
| C. | 14 litres |
| D. | 20 litres |
| Answer» D. 20 litres | |
| 15. |
A Persian wheel with an average discharge of 230 lit/min irrigates one-hectare wheat crop in 50 hours. The average depth of irrigation is |
| A. | 6.9 cm |
| B. | 7.2 cm |
| C. | 9.0 cm |
| D. | 9.6 cm |
| Answer» B. 7.2 cm | |
| 16. |
In pneumatic seed drill, seeds are released in the furrow under |
| A. | Gravity |
| B. | Pressure |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» C. Both (a) & (b) | |
| 17. |
A harrow with two gangs placed end to end is |
| A. | Offset disc harrow |
| B. | Tandem disc: harrow |
| C. | Single action disc harrow |
| D. | Double action disc harrow |
| Answer» D. Double action disc harrow | |
| 18. |
The ISI standard pan evaporimeter is the |
| A. | Same as US class A an |
| B. | Has average pan coefficient 0.7 |
| C. | Both (a) and (b) |
| D. | None of these |
| Answer» D. None of these | |
| 19. |
The specific fuel consumption of diesel engine is |
| A. | More than petrol engine |
| B. | Less than petrol engine |
| C. | Equal to petrol engine |
| D. | None of these |
| Answer» C. Equal to petrol engine | |
| 20. |
The first nuclear power station came into operation (1957) at |
| A. | IEA |
| B. | England |
| C. | Germany |
| D. | China |
| Answer» B. England | |
| 21. |
Depreciation of machine is computed on its |
| A. | Fixed cost |
| B. | Operating cost |
| C. | repair and maintenance cost |
| D. | All are correct |
| Answer» B. Operating cost | |
| 22. |
The blower of pneumatic seed drill is operated by |
| A. | Tractor PTO |
| B. | Tractor hydraulic |
| C. | Chain and sprocket |
| D. | Gear operated |
| Answer» B. Tractor hydraulic | |
| 23. |
During fruit juice canning, pasteurization is done at the temperature of |
| A. | 71?C |
| B. | 74?C |
| C. | 78?C |
| D. | 80?C |
| Answer» C. 78?C | |
| 24. |
Detachability of soil particle increases with |
| A. | Decreasing median grain size |
| B. | Increasing medium grain size |
| C. | Both (a) and (b) |
| D. | None of these |
| Answer» B. Increasing medium grain size | |
| 25. |
The movement of water in seepage is |
| A. | Downward |
| B. | Lateral |
| C. | Both (a) and (b) |
| D. | None of these |
| Answer» D. None of these | |
| 26. |
The motor of ultra low volume sprayer is powered by battery of |
| A. | 3?6 volt |
| B. | 6-12 volt |
| C. | 12-18 volt |
| D. | 12-24 volt |
| Answer» C. 12-18 volt | |
| 27. |
Mass density decreases with |
| A. | Temperature increase |
| B. | Temperature decrease |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» B. Temperature decrease | |
| 28. |
The advantage of air injection system is |
| A. | Good atomization |
| B. | Good mixing of air fuel |
| C. | Injection of heavy and viscous fuels |
| D. | All are correct |
| Answer» E. | |
| 29. |
The screw conveyours are generally used to move grains |
| A. | Vertically |
| B. | Horizontally |
| C. | At 45? inclination |
| D. | All are correct |
| Answer» C. At 45? inclination | |
| 30. |
The part of MB plough to which all other parts of plough bottom is attached is |
| A. | Mould board |
| B. | Land side |
| C. | Frog |
| D. | Coulter |
| Answer» D. Coulter | |
| 31. |
The camshaft gear is called |
| A. | Two time gear |
| B. | One time gear |
| C. | Halftime gear |
| D. | None of these |
| Answer» D. None of these | |
| 32. |
A special type of harrow with curved knives is |
| A. | Spike tooth harrow |
| B. | Spring type harrow |
| C. | Patela harrow |
| D. | Acme harrow |
| Answer» E. | |
| 33. |
Calorific value of hydrogen gas is |
| A. | 50 KJ/kg |
| B. | 100 KJ/kg |
| C. | 150 KJ/kg |
| D. | 180 KJ/kg |
| Answer» D. 180 KJ/kg | |
| 34. |
The specific gravity of high-speed diesel is |
| A. | 0.73 |
| B. | 0.87 |
| C. | 0.92 |
| D. | 0.95 |
| Answer» C. 0.92 | |
| 35. |
The firing interval of 2-stroke engine is determined by |
| A. | 180?/No. of cylinder |
| B. | 270?/No. of cylinder |
| C. | 360?/No. of cylinder |
| D. | 720?/No. of cylinder |
| Answer» D. 720?/No. of cylinder | |
| 36. |
A mirror used to reflect sublight in box type solar cooker is |
| A. | Convex |
| B. | Concave |
| C. | Plane |
| D. | All are correct |
| Answer» D. All are correct | |
| 37. |
Bomb calorimeter is used for determining |
| A. | Calorific value of fuel |
| B. | Gravity of fuel |
| C. | Cetane number of fuel |
| D. | SAE number of fuel |
| Answer» B. Gravity of fuel | |
| 38. |
The knife moves on the |
| A. | Guard |
| B. | Wearing plate |
| C. | Ledger plate |
| D. | All are correct |
| Answer» D. All are correct | |
| 39. |
The counter weight on a crankshaft is located opposite to |
| A. | Small end bearing |
| B. | Big end bearing |
| C. | Main bearing |
| D. | None of these |
| Answer» C. Main bearing | |
| 40. |
The firing interval of 2-stroke two-cylinder engine is |
| A. | 180 |
| B. | 360 |
| C. | 120 |
| D. | 720 |
| Answer» C. 120 | |
| 41. |
The most commonly used method for determination of centre of gravity of tractor is |
| A. | Suspension method |
| B. | Balancing method |
| C. | Weighing method |
| D. | All are correct |
| Answer» B. Balancing method | |
| 42. |
I-head type valves are generally used in |
| A. | Tractor engines |
| B. | Stationary engines |
| C. | Steam engines |
| D. | Both (a) & (b) |
| Answer» E. | |
| 43. |
When the bulk density of medium to fine textured subsoil exceeds about 1.7 g/cc the value of hydraulic conductivity of soil is |
| A. | Low |
| B. | Medium |
| C. | High |
| D. | None of these |
| Answer» B. Medium | |
| 44. |
Back furrow and dead furrows are left while ploughing with |
| A. | One-way plough |
| B. | Two-way plough |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» C. Both (a) & (b) | |
| 45. |
The permissible slip for crawler tractor during slippage testing is |
| A. | 3 to 5% |
| B. | 7 to 10% |
| C. | 15 to 20% |
| D. | 20 to 30% |
| Answer» C. 15 to 20% | |
| 46. |
Unit of noise is |
| A. | Kg per sq.cm |
| B. | Decible |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» C. Both (a) & (b) | |
| 47. |
Viscosity measured in |
| A. | Centistokes |
| B. | Centipoises |
| C. | Redwood seconds |
| D. | All are correct |
| Answer» E. | |
| 48. |
Surface planting with conservation feature of contour listing is |
| A. | Flat planting |
| B. | Furrow planting |
| C. | Ridge planting |
| D. | None of these |
| Answer» D. None of these | |
| 49. |
Lean air fuel mixture is required for |
| A. | Starting |
| B. | Cruising |
| C. | Idling |
| D. | All are correct |
| Answer» C. Idling | |
| 50. |
The main advantage of LSU dryer is |
| A. | Shorter drying period |
| B. | Maximum drying capacity |
| C. | Minimum drying losses |
| D. | All are correct |
| Answer» E. | |