MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Ratio of brake horsepower to indicated horsepower is |
| A. | Thermal efficiency |
| B. | Volumetric efficiency |
| C. | Mechanical efficiency |
| D. | Brake efficiency |
| Answer» D. Brake efficiency | |
| 2. |
The porosity of clayey soil usually ranges from |
| A. | 30 to 35 % |
| B. | 35 to 50% |
| C. | 40 to 60% |
| D. | 45 to 65% |
| Answer» D. 45 to 65% | |
| 3. |
Stroke law is applied when Reynoid's number is |
| A. | Less than 1 |
| B. | More than |
| C. | Less than 2 |
| D. | Less than or equal to |
| Answer» E. | |
| 4. |
Detonation results in |
| A. | Interruption in lubrication |
| B. | Delay in ignition |
| C. | Loss of power |
| D. | All are correct |
| Answer» D. All are correct | |
| 5. |
Diesel engine works on principle of |
| A. | Diesel cycle |
| B. | Otto cycle |
| C. | Carnot cycle |
| D. | None of these |
| Answer» B. Otto cycle | |
| 6. |
In battery ignition system primary cricuit includes |
| A. | Primary coil |
| B. | Secondary coil |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» B. Secondary coil | |
| 7. |
The action involved in harvesting of crops is |
| A. | Scissors action |
| B. | Tearing action |
| C. | Slicing action |
| D. | All are correct |
| Answer» E. | |
| 8. |
For hot climate the suitable type of tractor is |
| A. | Water cooled |
| B. | Air cooled |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» D. None of these | |
| 9. |
Percentage of bran in therice is |
| A. | 2-4% |
| B. | 4-6% |
| C. | 6-8% |
| D. | 8-10% |
| Answer» C. 6-8% | |
| 10. |
The major constitute of biogas is |
| A. | Methane |
| B. | Ethane |
| C. | Carbon dioxide |
| D. | Carbon monoxide |
| Answer» B. Ethane | |
| 11. |
A multi-crop thresher is used for threshing |
| A. | Wheat |
| B. | Paddy |
| C. | Soyabean |
| D. | All are correct |
| Answer» E. | |
| 12. |
The operating speed of combine harveter varies within a range of |
| A. | 600-800 rpm |
| B. | 900-1000 rpm |
| C. | 600-1400 rpm |
| D. | Above 1500 rpm |
| Answer» D. Above 1500 rpm | |
| 13. |
The percentage of protein by weight in pulse is |
| A. | 15-20% |
| B. | 17-5% |
| C. | 18-27% |
| D. | 20-30% |
| Answer» C. 18-27% | |
| 14. |
The firing order of 4 strokes 6 cylinder engine is |
| A. | 1-5-3-6-2-4 |
| B. | 1-3-4-2-6-5 |
| C. | 1-3-2-5-4-6 |
| D. | 1-3-5-6-4-2 |
| Answer» B. 1-3-4-2-6-5 | |
| 15. |
Final drive is a |
| A. | Speed increasing unit |
| B. | Speed reduction unit |
| C. | Torque increasing unit |
| D. | Torque reduction unit |
| Answer» C. Torque increasing unit | |
| 16. |
At proper alignment of mower the cutter bar is set at |
| A. | 20? inward |
| B. | 5? inward |
| C. | 10? inward |
| D. | 15? inward |
| Answer» B. 5? inward | |
| 17. |
In drying process, the heat required to convert one kilogram of grain moisture to water vapour is |
| A. | 450 kcal |
| B. | 500 kcal |
| C. | 550 kcal |
| D. | 650 kcal |
| Answer» E. | |
| 18. |
The weight of diesel engine per horsepower is |
| A. | Lighter than petrol engine |
| B. | Equal to petrol engine |
| C. | Heavier than petrol engine |
| D. | None of these |
| Answer» D. None of these | |
| 19. |
The pH value of sturry for better gas production should be between |
| A. | 3?5 |
| B. | 5?6 |
| C. | 7?8 |
| D. | 8?9 |
| Answer» D. 8?9 | |
| 20. |
A windmill suitable for water lifting is |
| A. | Single blade type |
| B. | Double blade type |
| C. | Triple blade type |
| D. | Multiple blade type |
| Answer» E. | |
| 21. |
In rotary type power duster, the speed of blower is |
| A. | 1000 rpm |
| B. | 2000 rpm |
| C. | 3000 rpm |
| D. | 4000 rpm |
| Answer» E. | |
| 22. |
Distillation test measures the |
| A. | Calorific value |
| B. | SAE number |
| C. | Voltility |
| D. | Power |
| Answer» B. SAE number | |
| 23. |
The specific fuel consumption of petrol engine is |
| A. | 180 gm/bhp/hr |
| B. | 200 gm/bhp/hr |
| C. | 150 gm/bhp/hr |
| D. | 290 gm/bhp/hr |
| Answer» E. | |
| 24. |
A dynamically balanced mower has crank speed of |
| A. | 900-1200 rpm |
| B. | 1000-1200 rpm |
| C. | 1000-1250 rpm |
| D. | 1000-1300 rpm |
| Answer» C. 1000-1250 rpm | |
| 25. |
The hydrological flood routing method used is |
| A. | Energy equation |
| B. | Equation of motion |
| C. | Equation of continuity |
| D. | All are correct |
| Answer» D. All are correct | |
| 26. |
The cutter bar of conventional combine is operated at |
| A. | 350-800 strokes/min |
| B. | 500-800 strokes/min |
| C. | 800-900 strokes/min |
| D. | 800-1200 strokes/min |
| Answer» D. 800-1200 strokes/min | |
| 27. |
Ultra low volume sprayer is used for application of |
| A. | Insecticides |
| B. | Pesticides |
| C. | Weedicides |
| D. | All are correct |
| Answer» D. All are correct | |
| 28. |
The mounted type seed drill attached to tractor by |
| A. | Single hitch point |
| B. | Two hitch-point |
| C. | Three point hitch |
| D. | Shank |
| Answer» D. Shank | |
| 29. |
The gap of spark plug generally should be |
| A. | 0.1 mm |
| B. | 0.3 mm |
| C. | 0.5 mm |
| D. | 0.6 mm |
| Answer» E. | |
| 30. |
The ratio of rolling resistance to dynamic load is |
| A. | Coefficient of traction |
| B. | Tractive efficiency |
| C. | Coefficient of rolling resistance |
| D. | Rolling resistance |
| Answer» D. Rolling resistance | |
| 31. |
Solid injection system is also known as |
| A. | Airless mechanical injection |
| B. | Air injection |
| C. | Jerk pump system |
| D. | All are correct |
| Answer» B. Air injection | |
| 32. |
Slogging or lugging ability is associated with |
| A. | Engine speed |
| B. | Engine torque |
| C. | Engine load |
| D. | All are correct |
| Answer» C. Engine load | |
| 33. |
A speed of centrifugal dehusker ranges between |
| A. | 1500-2000 rpm |
| B. | 2000-2500 rpm |
| C. | 2500-3000 rpm |
| D. | 3000-3500 rpm |
| Answer» D. 3000-3500 rpm | |
| 34. |
Mass curve of a rainfall of a storm is plotted between |
| A. | Accumulated precipitation and time in chronological order |
| B. | Accumulated rainfall intensity and time |
| C. | Rainfall intensity and time in chronological order |
| D. | None of these |
| Answer» B. Accumulated rainfall intensity and time | |
| 35. |
Universal Soil Loss Equation (USLE) is named because |
| A. | Its validity is more: |
| B. | It accounts all parameters affecting the soil loss |
| C. | It is universally adopted |
| D. | All are correct |
| Answer» C. It is universally adopted | |
| 36. |
In force feed lubrication system pump is driven by |
| A. | Camshaft |
| B. | Crankshaft |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» B. Crankshaft | |
| 37. |
When cam gear rotes one time the crankshaft gear will rotate |
| A. | Half time |
| B. | Two times |
| C. | Same rotation of cam gear |
| D. | Three times |
| Answer» C. Same rotation of cam gear | |
| 38. |
A pump used in force-feed lubrication system is |
| A. | Centrifugal pump |
| B. | Reciprocating pump |
| C. | Positive displacement pump |
| D. | None of these |
| Answer» D. None of these | |
| 39. |
Ring lubrication system is generally used for lubrication of |
| A. | Vertical bearings |
| B. | Horizontal bearings |
| C. | Inclined bearings |
| D. | None of these |
| Answer» C. Inclined bearings | |
| 40. |
Splash system of lubrication is generally used in |
| A. | Single cylinder & stationary engine |
| B. | Multi-cylinder engines |
| C. | Tractor engines |
| D. | All are correct |
| Answer» B. Multi-cylinder engines | |
| 41. |
A pump used in force feed lubricating system is |
| A. | Positive displacement type |
| B. | Gear type |
| C. | Vane type |
| D. | All are correct |
| Answer» E. | |
| 42. |
In force-feed cooling system thermostat valve begins to open at |
| A. | 70?C |
| B. | 74?C |
| C. | 78?C |
| D. | 80?C |
| Answer» C. 78?C | |
| 43. |
The output capacity of treading with bullock is |
| A. | 100 kg/h |
| B. | 120 kg/h |
| C. | 140 kg/h |
| D. | 160 kg/h |
| Answer» C. 140 kg/h | |
| 44. |
Force-feed lubrication system is commonly used in |
| A. | High speed multi-cylinder engine |
| B. | Tractor engines |
| C. | Truck and automobile engine |
| D. | All are correct |
| Answer» B. Tractor engines | |
| 45. |
Hand operated sprayers are suitable for |
| A. | Small holdings |
| B. | Medium holdings |
| C. | Large holdings |
| D. | Very large holdings |
| Answer» B. Medium holdings | |
| 46. |
Hand atomizer is used for spraying in |
| A. | Nursery |
| B. | Orchard |
| C. | Field crop |
| D. | None of these |
| Answer» B. Orchard | |
| 47. |
The output capacity of rotary power scythe is about |
| A. | 0.1-0.2 ha/day |
| B. | 0.2-0.4 ha/day |
| C. | 0.4-0.6 ha/day |
| D. | 0.4-0.8 ha/day |
| Answer» C. 0.4-0.6 ha/day | |
| 48. |
The average output capacity of tractor mounted groundnut digger shaker is |
| A. | 0.15 ha/h |
| B. | 0.20 ha/h |
| C. | 0.25 ha/h |
| D. | 0.27 ha/h |
| Answer» E. | |
| 49. |
The output capacity of rotary power scythe depends on |
| A. | Field condition |
| B. | Physique of operator |
| C. | Both (a) & (b) |
| D. | None of these |
| Answer» D. None of these | |
| 50. |
The capacity of hand dropper is about |
| A. | 0.1 ha/day |
| B. | 0.2 ha/day |
| C. | 0.3 ha/day |
| D. | 0.4 ha/day |
| Answer» C. 0.3 ha/day | |