Explore topic-wise MCQs in Chemical Engineering.

This section includes 408 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

Which will have the least volatile matter and hence will be the most difficult to ignite ?

A. Bituminous coal
B. Coke
C. Semi-bituminous coal
D. Anthracite
Answer» C. Semi-bituminous coal
2.

White flue gas (resembling steam) coming out of the chimney of a thermal power plant indicates that the fuel used in the boiler furnace is_________________?

A. Tar
B. Coke oven gas
C. Pitch
D. Pulverised coke
Answer» C. Pitch
3.

Width of the coke oven towards coke side is slightly more than that on pusher side to____________________?

A. Facilitate easy discharging of coke as it swells during carbonisation
B. Facilitate uniform heating of the oven
C. Increase the output of the coke
D. None of these
Answer» B. Facilitate uniform heating of the oven
4.

‘Wind loss’ resulting from unscientific storage of coal may be the order of about _____________ percent?

A. 2.5
B. 7.5
C. 10.5
D. 14.5
Answer» B. 7.5
5.

With increase in calorific value of fuels, their adiabatic flame temperatures__________________?

A. Increase
B. Decrease
C. Remain unchanged
D. May increase or decrease; depends on the quantity of products of combustion
Answer» E.
6.

With increase in C/H ratio of a fuel, the amount of CO2 formed on its complete combustion____________________?

A. Increases
B. Decreases
C. Remain same
D. Either A. or B., depends on other factors
Answer» B. Decreases
7.

With increase in C/H ratio of a fuel, the dew point of flue gases______________________?

A. Increases
B. Decreases
C. Remain same
D. May increase or decrease; depends on the type of fuel
Answer» C. Remain same
8.

With increase in moisture content of coal, its___________________?

A. Calorific value increases
B. Caking properties diminish
C. Swelling during carbonisation becomes excessive
D. None of these
Answer» C. Swelling during carbonisation becomes excessive
9.

With increase in moisture content of coal, its_____________________?

A. Calorific value increases sometimes
B. Bulk density always decreases
C. Clinkering tendency during combustion increases
D. None of these
Answer» E.
10.

With increase in the oxygen content of the coal, its ______________ decreases?

A. Calorific value
B. Caking power
C. Both A. & B.
D. Neither A. nor B.
Answer» D. Neither A. nor B.
11.

With increase in the temperature of carbonisation of coal ___________________?

A. Hydrogen content of coke oven gas increases due to cracking of hydrocarbons
B. Methane content in the coke oven gas decreases and carbon monoxide content increases
C. Calorific value of the coke oven gas decreases due to cracking of hydrocarbons which is not compensated by increase in CO & H2 content
D. All A., B. and C.
Answer» E.
12.

With increases in carbonisation temperature_______________________?

A. Coke even gas yield increases
B. Tar yield increases
C. Hydrogen percentage in the coke oven gas decreases
D. Methane percentage in the coke oven gas increases
Answer» B. Tar yield increases
13.

With increase in the time of carbonisation at a particular temperature (say 1000°C), the ______________ percentage in coke oven gas increases?

A. Hydrogen
B. Methane
C. Unsaturated hydrocarbons
D. All A., B. and C.
Answer» B. Methane
14.

‘Wobbe index’ is a characteristic of__________________?

A. Solid fuels
B. Gaseous fuels
C. Liquid fuels
D. Fat coals
Answer» C. Liquid fuels
15.

Wood charcoal is obtained by the destructive distillation of wood. It is used in the production of activated carbon, which is not used for the____________________?

A. Decolourisation of sugar
B. Solvent recovery from air and gases
C. Absorption of gases and vapor
D. Electrode manufacture
Answer» E.
16.

Yield of blast furnace gas is about _______________ Nm3 /ton of pig iron?

A. 300
B. 2000
C. 5000
D. 10000
Answer» C. 5000
17.

Yield of charcoal in high temperature carbonisation of wood is about _____________ percent?

A. 10
B. 25
C. 50
D. 75
Answer» C. 50
18.

Yield of coke oven gas in low temperature carbonisation of coal is about ______________ Nm3 /ton of dry coal?

A. 60
B. 160
C. 500
D. 750
Answer» C. 500
19.

Yield of pitch from distillation of high temperature tar is around _____________ percent?

A. 10
B. 25
C. 65
D. 90
Answer» D. 90
20.

Which of the following is used for making the explosive „TNT‟ ?

A. Benzol
B. Toluene
C. Pyridine
D. Cerosote
Answer» C. Pyridine
21.

Which of the following is not endothermic ?

A. Cracking
B. Reforming
C. Gasification
D. Partial oxidation
Answer» E.
22.

Which of the following is not a ‘manufactured’ fuel ?

A. LPG
B. Coal briquettes
C. Tar
D. Colloidal fuels
Answer» D. Colloidal fuels
23.

Which of the following is called “blue gas”?

A. Coke oven gas
B. Water gas
C. Natural gas
D. Producer gas
Answer» C. Natural gas
24.

Which of the following is a poisonous fuel gas ?

A. Coke oven gas
B. Blast furnace gas
C. Natural gas
D. None of these
Answer» C. Natural gas
25.

Which of the following is a measure of the agglutinating (i.e., binding) property of coal ?

A. Thickness of plastic layer
B. Caking index
C. Swelling index
D. Gray-king index
Answer» C. Swelling index
26.

Which of the following has the least calorific value (kcal/Nm3) ?

A. Blast furnace gas
B. Coke oven gas
C. Sewage gas
D. Natural gas
Answer» B. Coke oven gas
27.

Which of the following has the highest heat of combustion ?

A. H2
B. CO
C. CH4
D. C2H6
Answer» E.
28.

Which of the following has the highest calorific value (kcal/Nm3) ?

A. Carburetted water gas
B. Gobar gas
C. Natural gas
D. LPG
Answer» E.
29.

Which of the following gaseous fuels is likely to have the highest gross calorific value ?

A. Sewage gas
B. LPG
C. Producer gas
D. Natural gas
Answer» C. Producer gas
30.

Which of the following gaseous fuels has the highest net calorific value (kcal/Nm3) ?

A. Producer gas
B. Carburetted water gas
C. Natural gas
D. Liquefied petroleum gas
Answer» E.
31.

Which of the following fuels is generally not used in thermal power plant boiler firing ?

A. Furnace oil, light diesel oil and tar/PCM
B. Pulverised coking coal
C. Coal middling from washeries
D. B.F. gas, coke oven gas and L.D. converter gas
Answer» C. Coal middling from washeries
32.

Which of the following constituents of coal is the most important in the production of coke ?

A. Moisture
B. Ash
C. Volatiles
D. Carbon
Answer» E.
33.

Which of the following accentuates clinkering trouble on furnace grate burning coal ?

A. Low reactivity of carbonised residue containing high proportions of iron & sulphur
B. Low forced draught and fuel bed temperature
C. Thick fire bed and preheated primary air
D. All A., B. and C.
Answer» E.
34.

Which adsorbent is used for removing sulphur compounds (S Q, H2S, RSH etc.) removal from coke oven gas in by-products recovery plant ?

A. Silica gel
B. Diatomaceous earth
C. Basalt
D. Bog iron (i.e., moist ferric hydroxide)
Answer» E.
35.

When the coal is heated in absence of air, it is called its ________________?

A. Deoxidation
B. Gasification
C. Coalification
D. Carbonisation
Answer» E.
36.

When steam is passed over coal resulting in the endothermic reaction represent by, C + H2O = CO + H2, it is called the _______________ of coal?

A. Carbonisation
B. Oxidation
C. Coalification
D. Gasification
Answer» E.
37.

When incomplete combustion loss is high, the flue gas analysis shows large amount of ________________?

A. CO2
B. CO
C. O2
D. C
Answer» C. O2
38.

Weathering of coal during storage causes_______________?

A. Reduction in coal size
B. Increase in its friability
C. Decrease in its caking capacity
D. All A., B. and C.
Answer» E.
39.

Water gas constitutes mainly of __________________?

A. CO & H2
B. CO & N2
C. CO2 & H2
D. CH4 & H2
Answer» B. CO & N2
40.

Washing of coal________________?

A. Reduces its sulphur and ash content
B. Controls its ash fusibility and increases its calorific value
C. Improves its coking properties
D. All A., B. and C.
Answer» E.
41.

Washing of coal _________________?

A. Reduces its ash & sulphur content
B. Improves its coking properties
C. Increase the fusion point of its ash by removing chlorine compounds
D. All A., B. and C.
Answer» E.
42.

Washing of coal is done to reduce the_________________?

A. Inherent impurities
B. Adhering impurities
C. Mineral matter
D. Both B. and C.
Answer» E.
43.

Washing of coal decreases its_________________?

A. Caking index
B. Mineral matter content
C. Ash content
D. Both B. and C.
Answer» C. Ash content
44.

Washing of coal does not reduce its______________________?

A. S & P content
B. Heating value
C. Fusion point of ash
D. None of these
Answer» E.
45.

Volumetric ratio of N2 to O2 in dry atmospheric air is ______________?

A. 0.21
B. 3.76
C. 4.76
D. 0.79
Answer» C. 4.76
46.

Volatile matter content in coking coal may be about _____________ percent?

A. 1
B. 7
C. 22
D. 46
Answer» D. 46
47.

Volatile matter content of metallurgical coke may be around ______________ percent?

A. 1-2
B. 10-15
C. 22-26
D. 30-33
Answer» B. 10-15
48.

Very ______________ coals are completely devoid of cokability i.e., it is non-coking ?

A. Young
B. Mature
C. Both A & B
D. Neither A nor B
Answer» D. Neither A nor B
49.

Use of preheated air for combustion of fuel in the furnace, increases the___________________?

A. Scale losses of the furnace stock
B. Calorific value of the fuel
C. Flame temperature
D. None of these
Answer» D. None of these
50.

Use of pulverised coal in boiler furnace provides___________________?

A. High calorific value
B. Better combustion
C. Smokeless burning
D. Less erosion on furnace walls
Answer» C. Smokeless burning