

MCQOPTIONS
Saved Bookmarks
This section includes 8 Mcqs, each offering curated multiple-choice questions to sharpen your Electronic Devices Circuits knowledge and support exam preparation. Choose a topic below to get started.
1. |
Under what condition can the circuit shown be called a compensated attenuator. |
A. | C1R1 = C2R2 |
B. | C1R2 = C2R1 |
C. | C1C2 = R1R2 |
D. | R1 = 0 |
Answer» B. C1R2 = C2R1 | |
2. |
When a circuit is called compensated attenuator? |
A. | Transfer function is directly proportional to the frequency |
B. | Transfer function is inversely proportional to the frequency |
C. | Transfer function is independent of the frequency |
D. | Natural log of the transfer function is proportional to the frequency |
Answer» D. Natural log of the transfer function is proportional to the frequency | |
3. |
General representation of the frequency response curve is called |
A. | Bode Plot |
B. | Miller Plot |
C. | Thevenin Plot |
D. | Bandwidth Plot |
Answer» B. Miller Plot | |
4. |
Which of the following is not a classification of amplifiers on the basis of their frequency response? |
A. | Capacitively coupled amplifier |
B. | Direct coupled amplifier |
C. | Bandpass amplifier |
D. | None of the mentioned |
Answer» E. | |
5. |
The signal whose waveform is not effected by a linear circuit is |
A. | Triangular Waveform signal |
B. | Rectangular waveform signal |
C. | Sine/Cosine wave signal |
D. | Sawtooth waveform signal |
Answer» D. Sawtooth waveform signal | |
6. |
Single-time-constant (STC) networks are those networks that are composed of, or can be reduced to |
A. | One reactive component (L or C) and a resistance (R) |
B. | Only capacitive component (C) and resistance (R) |
C. | Only inductive component (L) and resistance (R) |
D. | Reactive components (L, C or both L and C) and resistance (R) |
Answer» B. Only capacitive component (C) and resistance (R) | |
7. |
STC networks can be classified into two categories: low-pass (LP) and high-pass (HP). Then which of the following is true? |
A. | HP network passes dc and low frequencies and attenuate high frequency and opposite for LP network |
B. | LP network passes dc and low frequencies and attenuate high frequency and opposite for HP network |
C. | HP network passes dc and high frequencies and attenuate low frequency and opposite for LP network |
D. | LP network passes low frequencies only and attenuate high frequency and opposite for HP network |
Answer» C. HP network passes dc and high frequencies and attenuate low frequency and opposite for LP network | |
8. |
Consider a voltage amplifier having a frequency response of the low-pass STC type with a dc gain of 60 dB and a 3-dB frequency of 1000 Hz. Then the gain db at |
A. | f = 10 Hz is 55 db |
B. | f = 10 kHz is 45 db |
C. | f = 100 kHz is 25 db |
D. | f = 1Mhz is 0 db |
Answer» E. | |