

MCQOPTIONS
Saved Bookmarks
This section includes 303 Mcqs, each offering curated multiple-choice questions to sharpen your Electronics knowledge and support exam preparation. Choose a topic below to get started.
201. |
In parallel resonance, the circuit impedance is ___________ |
A. | C/LR |
B. | R/LC |
C. | CR/L |
D. | L/CR |
Answer» E. | |
202. |
In a parallel LC circuit, if the signal frequency is decreased below the resonant frequency, then ___________ |
A. | XL decreases and XC increases |
B. | XL increases and XC decreases |
C. | Line current becomes minimum |
D. | None of the above |
Answer» B. XL increases and XC decreases | |
203. |
In the above question, what are the values of cut-off frequencies? |
A. | 140 kHz , 60 kHz |
B. | 1020 kHz , 980 kHz |
C. | 1030 kHz , 970 kHz |
D. | None of the above |
Answer» C. 1030 kHz , 970 kHz | |
204. |
The arrow in the symbol of a transistor indicates the direction of ___________ |
A. | electron current in the emitter |
B. | electron current in the collector |
C. | hole current in the emitter |
D. | donor ion current |
Answer» D. donor ion current | |
205. |
In the double tuned circuit, if the mutual inductance between the two tuned circuits is decreased, the level of resonance curve ___________ |
A. | Remains the same |
B. | Is lowered |
C. | Is raised |
D. | None of the above |
Answer» D. None of the above | |
206. |
The leakage current in CE arrangement is ___________ that in CB arrangement |
A. | more than |
B. | less than |
C. | the same as |
D. | none of the above |
Answer» B. less than | |
207. |
In a transistor ___________ |
A. | IC = IE + IB |
B. | IB = IC + IE |
C. | IE = IC - IB |
D. | IE = IC + IB |
Answer» E. | |
208. |
The input impedance of a transistor connected in ___________ arrangement is the highest |
A. | common emitter |
B. | common collector |
C. | common base |
D. | none of the above |
Answer» C. common base | |
209. |
The voltage gain of a transistor connected in common collector arrangement is ___________ |
A. | equal to 1 |
B. | more than 10 |
C. | more than 100 |
D. | less than 1 |
Answer» E. | |
210. |
The phase difference between the input and output voltages in a common base arrangement is ___________ |
A. | 180° |
B. | 90° |
C. | 270° |
D. | 0° |
Answer» E. | |
211. |
Frequencies above ___________ kHz are called radio frequencies |
A. | 2 |
B. | 10 |
C. | 50 |
D. | 200 |
Answer» E. | |
212. |
If the temperature increases, the value of VCE ___________ |
A. | Remains the same |
B. | Is increased |
C. | Is decreased |
D. | None of the above |
Answer» D. None of the above | |
213. |
If Q of an LC circuit increases, then bandwidth ___________ |
A. | Increases |
B. | Decreases |
C. | Remains the same |
D. | Insufficient data |
Answer» C. Remains the same | |
214. |
The relation between ß and a is ___________ |
A. | ß = 1 / (1 – a ) |
B. | ß = (1 – a ) / a |
C. | ß = a / (1 – a ) |
D. | ß = a / (1 + a ) |
Answer» D. ß = a / (1 + a ) | |
215. |
At series or parallel resonance, the circuit power factor is ___________ |
A. | 0% |
B. | 5% |
C. | 10% |
D. | 8% |
Answer» D. 8% | |
216. |
An ideal value of stability factor is ___________ |
A. | 100 |
B. | 200 |
C. | More than 200 |
D. | 1 |
Answer» E. | |
217. |
For faithful amplification by a transistor circuit, the value of VBE should ___________ for a silicon transistor |
A. | Be zero |
B. | Be 0.01 V |
C. | Not fall below 0.7 V |
D. | Be between 0 V and 0.1 V |
Answer» D. Be between 0 V and 0.1 V | |
218. |
IC = ß IB + ___________ |
A. | ICBO |
B. | IC |
C. | ICEO |
D. | aIE |
Answer» D. aIE | |
219. |
A resonant circuit contains ___________ elements |
A. | R and L only |
B. | R and C only |
C. | Only R |
D. | L and C |
Answer» E. | |
220. |
If a high degree of selectivity is desired, then double-tuned circuit should have ___________ coupling |
A. | Loose |
B. | Tight |
C. | Critical |
D. | None of the above |
Answer» B. Tight | |
221. |
A tuned amplifier is generally operated in ___________ operation |
A. | Class A |
B. | Class C |
C. | Class B |
D. | None of the above |
Answer» C. Class B | |
222. |
At series resonance, the circuit offers ___________ impedance |
A. | Zero |
B. | Maximum |
C. | Minimum |
D. | None of the above |
Answer» D. None of the above | |
223. |
Transistor biasing represents ___________ conditions |
A. | a.c. |
B. | d.c. |
C. | both a.c. and d.c. |
D. | none of the above |
Answer» C. both a.c. and d.c. | |
224. |
The most commonly used transistor arrangement is ___________ arrangement |
A. | common emitter |
B. | common base |
C. | common collector |
D. | none of the above |
Answer» B. common base | |
225. |
A tuned amplifier is used in ___________ applications |
A. | Radio frequency |
B. | Low frequency |
C. | Audio frequency |
D. | None of the above |
Answer» B. Low frequency | |
226. |
Transistor biasing is done to keep ___________ in the circuit |
A. | Proper direct current |
B. | Proper alternating current |
C. | The base current small |
D. | Collector current small |
Answer» B. Proper alternating current | |
227. |
A transistor is a ___________ operated device |
A. | current |
B. | voltage |
C. | both voltage and current |
D. | none of the above |
Answer» B. voltage | |
228. |
At series resonance, voltage across L is ___________ voltage across C |
A. | Equal to but opposite in phase to |
B. | Equal to but in phase with |
C. | Greater than but in phase with |
D. | Less than but in phase with |
Answer» B. Equal to but in phase with | |
229. |
In a transistor, the base current is about ___________ of emitter current |
A. | 25% |
B. | 20% |
C. | 35% |
D. | 5% |
Answer» E. | |
230. |
IC = [a / (1 - a )] IB + [ / (1 - a )] |
A. | ICBO |
B. | ICEO |
C. | IC |
D. | IE |
Answer» B. ICEO | |
231. |
The dimensions of L/CR are that of ___________ |
A. | Farad |
B. | Henry |
C. | Ohm |
D. | None of the above |
Answer» D. None of the above | |
232. |
The disadvantage of base resistor method of transistor biasing is that it ___________ |
A. | Is complicated |
B. | Is sensitive to changes in ß |
C. | Provides high stability |
D. | None of the above |
Answer» C. Provides high stability | |
233. |
A transistor is connected in CB mode. If it is not connected in CE mode with same bias voltages, the values of IE, IB and IC will ___________ |
A. | remain the same |
B. | increase |
C. | decrease |
D. | none of the above |
Answer» B. increase | |
234. |
Most of the majority carriers from the emitter ___________ |
A. | recombine in the base |
B. | recombine in the emitter |
C. | pass through the base region to the collector |
D. | none of the above |
Answer» D. none of the above | |
235. |
If the resistance of a tuned circuit is increased, the Q of the circuit ___________ |
A. | Is increased |
B. | Is decreased |
C. | Remains the same |
D. | None of the above |
Answer» C. Remains the same | |
236. |
If L/C ratio of a parallel LC circuit is increased, the Q of the circuit ___________ |
A. | Is decreased |
B. | Is increased |
C. | Remains the same |
D. | None of the above |
Answer» C. Remains the same | |
237. |
When either L or C is increased, the resonant frequency of LC circuit ___________ |
A. | Remains the same |
B. | Increases |
C. | Decreases |
D. | Insufficient data |
Answer» D. Insufficient data | |
238. |
If the value of a is 0.9, then value of ß is ___________ |
A. | 9 |
B. | 0.9 |
C. | 900 |
D. | 90 |
Answer» E. | |
239. |
In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of ß is ___________ |
A. | 100 |
B. | 50 |
C. | about 1 |
D. | 200 |
Answer» E. | |
240. |
Double tuned circuits are used in ___________ stages of a radio receiver |
A. | IF |
B. | Audio |
C. | Output |
D. | None of the above |
Answer» B. Audio | |
241. |
BC 147 transistor indicates that it is made of ___________ |
A. | germanium |
B. | silicon |
C. | carbon |
D. | none of the above |
Answer» C. carbon | |
242. |
When the temperature changes, the operating point is shifted due to . |
A. | Change in ICBO |
B. | Change in VCC |
C. | Change in the values of circuit resistance |
D. | None of the above |
Answer» B. Change in VCC | |
243. |
The stability factor of a collector feedback bias circuit is ___________ that of base resistor bias. |
A. | The same as |
B. | More than |
C. | Less than |
D. | None of the above |
Answer» D. None of the above | |
244. |
In a transistor amplifier circuit VCE = VCB + ___________ |
A. | VBE |
B. | 2 VBE |
C. | 5 VBE |
D. | None of the above |
Answer» B. 2 VBE | |
245. |
IC = aIE + ___________ |
A. | IB |
B. | ICEO |
C. | ICBO |
D. | ßIB |
Answer» D. ßIB | |
246. |
In a transistor, signal is transferred from a ___________ circuit |
A. | high resistance to low resistance |
B. | low resistance to high resistance |
C. | high resistance to high resistance |
D. | low resistance to low resistance |
Answer» C. high resistance to high resistance | |
247. |
IC = [a / (1 - a )] IB + ___________ |
A. | ICEO |
B. | ICBO |
C. | IC |
D. | (1 - a ) IB |
Answer» B. ICBO | |
248. |
A MOSFET differs from a JFET mainly because ___________ |
A. | of power rating |
B. | the MOSFET has two gates |
C. | the JFET has a pn junction |
D. | none of the above |
Answer» D. none of the above | |
249. |
A JFET has high input impedance because ___________ |
A. | it is made of semiconductor material |
B. | input is reverse biased |
C. | of impurity atoms |
D. | none of the above |
Answer» C. of impurity atoms | |
250. |
The constant-current region of a JFET lies between |
A. | cut off and saturation |
B. | cut off and pinch-off |
C. | o and IDSS |
D. | pinch-off and breakdown |
Answer» E. | |