Explore topic-wise MCQs in Chemical Engineering.

This section includes 38 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

Catalyst used in the manufacture of NH3 by Haber\'s process is finely divided

A. iron
B. nickel
C. alumina
D. vanadium pentoxide
Answer» B. nickel
2.

During nitric acid manufacture, catalytic oxidation of ammonia at 800°C in presence of platinum catalyst produces nitrogen oxide. Conversion of NH 3 to NO is about __________ percent.

A. 38
B. 68
C. 82
D. 98
Answer» E.
3.

P 2 O 5 content in superphosphate is about __________ percent.

A. 30-35
B. 15-20
C. 65-70
D. 85-90
Answer» C. 65-70
4.

Though kinetics of ammonia synthesis dictates the use of low temperature for high equilibrium conversion, yet it is kept moderately high (550°C), because at low temperature

A. rate of reaction is very low.
B. very high pressure is required resulting in costly pressure vessel.
C. space velocity of gas is very low resulting in decreased conversion.
D. none of these
Answer» B. very high pressure is required resulting in costly pressure vessel.
5.

P 2 O 5 percentage in the phosphoric acid produced by wet process is about

A. 10
B. 30
C. 50
D. 70
Answer» C. 50
6.

An increase in the NH 3 /CO 2 ratio in urea manufacture results in

A. increased degree of conversion of CO 2 to urea.
B. decreased degree of conversion of NH 3 to urea.
C. decreased yield of urea.
D. decreased specific volume of molten mass.
Answer» B. decreased degree of conversion of NH 3 to urea.
7.

Which of the following solvents is used for the extraction of H 3 PO 4 from CaCl 2 solution during manufacture of ortho-phosphoric acid by wet process employing hydrochloric acid leaching?

A. Iso propyl alcohol
B. Butyl alcohol
C. Toluene
D. Hexane
Answer» C. Toluene
8.

Triple superphosphate which contains about 46% P 2 O 5 is produced by the reaction of phosphate rock with ortho phosphoric acid of____percent concentration.

A. 25-28
B. 52-54
C. 75-80
D. > 98
Answer» C. 75-80
9.

In the manufacture of orthophosphoric acid by strong H 2 SO 4 leaching wet process, keeping the reactor temperature above 100°C, results in the formation of undesriable

A. CaSO 4 . H 2 O and CaSO 4 crystals
B. pyrophosphoric acid
C. metaphosphoric acid
D. all (a), (b) and (c).
Answer» B. pyrophosphoric acid
10.

Out of the following, N 2 content is minimum in

A. urea
B. ammonium nitrate
C. ammonium sulphate
D. ammonium chloride
Answer» D. ammonium chloride
11.

Raw materials required for the production of CAN (Calcium ammonium nitrate) is NH 3

A. HNO 3 & limestone
B. CO 2 & H 2 SO 4
C. HNO 3 & NH 4 Cl
D. CO 2 & KNO 3
Answer» B. CO 2 & H 2 SO 4
12.

Conversion achieved in HNO 3 synthesis with the use of platinum catalyst is about 95-97%. The rate of formation of nitrogen dioxide from the oxidation of nitric acid is favoured by

A. decreasing the pressure.
B. decreasing the temperature.
C. increasing the temperature.
D. none of these.
Answer» D. none of these.
13.

Optimum reaction temperature in steam reforming of naphtha is __________ °C.

A. 700 - 1000
B. 300 - 450
C. 1500-1700
D. 100-200
Answer» B. 300 - 450
14.

Conversion of yellow phosphorus to red phosphorous is done in retorts at 250-450°C in the

A. presence of an inert atmosphere.
B. presence of a reducing atmosphere.
C. absence of air.
D. presence of an oxidising atmosphere.
Answer» D. presence of an oxidising atmosphere.
15.

CaH 4 (PO 4 ) 2 is the chemical formula of

A. superphosphate
B. triple superphosphate
C. calcium phosphate
D. meta phosphoric acid
Answer» C. calcium phosphate
16.

A potassic fertiliser contains 50% K 2 O. It could be

A. potassium sulphate.
B. potassium chloride.
C. a mixture of NaCl+ KCl.
D. none of these.
Answer» B. potassium chloride.
17.

Formation of ammonium carbamate by reaction of NH 3 with CO 2 is a/an __________ reaction.

A. catalytic
B. exothermic
C. endothermic
D. reversible
Answer» C. endothermic
18.

Fusion zone in the electric furnace used for reduction of phosphate rock to elemental phosphorous is maintained at __________ °C.

A. 250-300
B. 500-750
C. 950-1050
D. 1400-1450
Answer» E.
19.

A phosphatic fertiliser contains 16% P 2 O 5 . It could be

A. dicalcium phosphate
B. superphosphate
C. triple superphosphate
D. none of these
Answer» C. triple superphosphate
20.

In the manufacture of H 3 PO 4 (ortho), ; strong H 2 SO 4 leaching wet process as compared to electric furnace process

A. uses lower grade phosphate rock.
B. requires lower capital investment in the plant.
C. produces lower purity acid.
D. is very costly.
Answer» D. is very costly.
21.

A nitrogenous fertiliser contains 20% N 2 . It could be

A. ammonium nitrate.
B. calcium ammonium nitrate (CAN).
C. urea.
D. ammonium chloride.
Answer» C. urea.
22.

In ammonia synthesis (N 2 + 3H 2 = 2NH 3 ), there is a decrease in total volume, hence to get high equilibrium conversion, the reaction should be carried out at

A. low pressure.
B. high pressure.
C. very high temperature.
D. atmospheric pressure; as the pressure has no effect on conversion.
Answer» C. very high temperature.
23.

I argest capacity nitrogenous fertiliser plants (2700 tons of NH 3 per day) (2 Nos) in India are located at

A. Thal-Vaishet (under RCF in Maharashtra) and Hazira (under IFFCO in Gujarat).
B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI.
C. Korba (M.P.) and Talchar (Orissa) both under FCI.
D. Haldia (W.B) and Namrup (Assam) both under HFC.
Answer» B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI.
24.

H 4 P 2 O 7 is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» B. ortho
25.

HPO 3 is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» D. none of these
26.

Reaction of phosphate rock with 98% H 2 SO 4 produces

A. orthophosphoric acid
B. superphosphate
C. white phosphorous
D. none of these
Answer» B. superphosphate
27.

Heating of orthophosphoric acid to about 900°C, produces

A. metaphosphoric acid
B. pyrophosphoric acid
C. no change in it
D. none of these
Answer» B. pyrophosphoric acid
28.

A fertiliser contains 82% N 2 . It could be

A. urea
B. liquid NH 3
C. ammonium nitrate
D. none of these
Answer» C. ammonium nitrate
29.

Multistage operation (as in the case of catalytic oxidation of SO 2 ) is not carried out for NH 3 synthesis, because of

A. comparatively higher pressure drop.
B. high cost of the high pressure vessel used for the reactor.
C. higher pumping cost.
D. chances of entrainment and disturbance of catalyst bed.
Answer» C. higher pumping cost.
30.

Use of catalyst is a must in the ammonia manufacture, because the reaction is reversible as well as the heat of dissociation of N 2 & H 2 is high. The presence of promoter along with the catalyst helps in __________ of the catalyst.

A. stabilisation
B. increasing the effectiveness
C. improving the strength & heat resistance
D. all a, b & c
Answer» E.
31.

Heating of orthophosphoric acid to 250°C produces

A. metaphosphoric acid
B. pyrophosphoric acid
C. no change in it
D. none of these
Answer» C. no change in it
32.

H 3 PO 4 is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» C. meta
33.

P 2 O 5 content in triple superphosphate is about __________ percent.

A. 42-50
B. 15-20
C. 85-90
D. 70-75
Answer» B. 15-20
34.

CO 2 present in reformed gas (obtained by steam reforming of naphtha) is removed by absorbing in

A. mono-ethanolamine (MEA)
B. slaked lime
C. ammoniacal liquor
D. Methyl-Ethyl Ketone (MEK)
Answer» B. slaked lime
35.

(CH 3 C 6 H 4 ) 3 PO 4 is the chemical formula of

A. triple superphosphate
B. tricresyl phosphate
C. flourapatite
D. superphosphate
Answer» C. flourapatite
36.

Fertiliser plants get their N 2 requirements

A. by fractionation of liquified air.
B. by dissociating oxides of nitrogen.
C. from coal gas (coke oven gas).
D. from producer gas.
Answer» B. by dissociating oxides of nitrogen.
37.

Catalyst used in the manufacture of NH 3 by Haber's process is finely divided

A. nickel
B. iron
C. vanadium pentoxide
D. alumina
Answer» C. vanadium pentoxide
38.

Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air.

A. 50-80
B. 250-400
C. 1000-1200
D. 800-900
Answer» C. 1000-1200