MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 6 Mcqs, each offering curated multiple-choice questions to sharpen your Machine Drawing knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
The method in which it uses the alphabet for dimensioning is called as ________ |
| A. | vertical dimensioning |
| B. | tabular dimensioning |
| C. | combined dimensioning |
| D. | horizontal dimensioning |
| Answer» C. combined dimensioning | |
| 2. |
The method in which it uses the same reference or datum which is used by another dimensioning method is called __________ |
| A. | vertical dimensioning |
| B. | inclined dimensioning |
| C. | combined dimensioning |
| D. | horizontal dimensioning |
| Answer» D. horizontal dimensioning | |
| 3. |
The dimension which is measured with the help of the reference line is called _________ |
| A. | parallel dimensioning |
| B. | superimposed running dimensioning |
| C. | combined dimensioning |
| D. | tabular dimensioning |
| Answer» B. superimposed running dimensioning | |
| 4. |
The method which starts with a circle is called as ___________ |
| A. | parallel dimensioning |
| B. | superimposed running dimensioning |
| C. | combined dimensioning |
| D. | tabular dimensioning |
| Answer» C. combined dimensioning | |
| 5. |
The method in which the series of dimensions are applied from one point to other is called _________ |
| A. | Parallel dimension |
| B. | Chain dimensioning |
| C. | Combined dimensioning |
| D. | Tabular dimensioning |
| Answer» C. Combined dimensioning | |
| 6. |
In dimensioning a 2D sketch, to dimension the radius of the arc ________ |
| A. | click on the two end points of arc |
| B. | click on the arc only |
| C. | click one of the end point and the arc |
| D. | click on the center point and arc |
| Answer» C. click one of the end point and the arc | |