

MCQOPTIONS
Saved Bookmarks
This section includes 12 Mcqs, each offering curated multiple-choice questions to sharpen your Electric Drives knowledge and support exam preparation. Choose a topic below to get started.
1. |
Calculate the active power in an 8 resistor with 8 A current flowing through it. |
A. | 512 W |
B. | 514 W |
C. | 512 W |
D. | 518 W |
Answer» B. 514 W | |
2. |
For a practical synchronous motor, the pull-out torque will occur when the torque angle is nearly equal to ________ |
A. | 0 |
B. | 30 |
C. | 45 |
D. | 75 |
Answer» E. | |
3. |
A 3-phase induction motor runs at almost 1500 rpm at no load and 900 rpm at full load when supplied with power from a 50 Hz, 3-phase supply. What is the corresponding speed of the rotor field with respect to the rotor? |
A. | 300 revolution per minute |
B. | 400 revolution per minute |
C. | 600 revolution per minute |
D. | 500 revolution per minute |
Answer» D. 500 revolution per minute | |
4. |
In an induction motor, when the number of stator slots is not equal to an integral number of rotor slots _________ |
A. | There may be a discontinuity in torque slip characteristics |
B. | A high starting torque will be available |
C. | The machine performs better |
D. | The machine may fail to start |
Answer» D. The machine may fail to start | |
5. |
The slope of the V-I curve is 7 . Calculate the value of resistance. Assume the relationship between voltage and current is a straight line. |
A. | .122 |
B. | .360 |
C. | .377 |
D. | .578 |
Answer» B. .360 | |
6. |
In a synchronous machine, the phase sequence can be reversed by reversing the _________ |
A. | Rotor direction |
B. | Field polarities |
C. | Armature terminal |
D. | Rotor direction and armature terminal |
Answer» B. Field polarities | |
7. |
Which of the following are used in preventing the hunting phenomenon in synchronous generators? |
A. | Damper bars |
B. | Short pitch chords |
C. | Distributed winding |
D. | Damper bars and short pitch chords |
Answer» B. Short pitch chords | |
8. |
The hunting phenomenon in a synchronous motor is also referred to as _________ |
A. | Surging |
B. | Phase swinging |
C. | Cogging |
D. | Surging and phase swinging |
Answer» E. | |
9. |
The leakage flux paths are ________ on the angular position of the rotor. |
A. | Dependent |
B. | Proportional |
C. | Independent |
D. | Dependent and independent |
Answer» D. Dependent and independent | |
10. |
Calculate the phase angle of the sinusoidal waveform z(t)=8cos(45t+2 15). |
A. | 2 39 |
B. | 2 15 |
C. | 4 |
D. | 2 44 |
Answer» C. 4 | |
11. |
A 4-pole, 3-phase, 60 Hz induction motor is operating at a speed of 1500 rpm. The frequency of the rotor current of the motor in Hz is __________ |
A. | 5 |
B. | 4 |
C. | 2 |
D. | 7 |
Answer» C. 2 | |
12. |
The direct axis is taken along ________ |
A. | Inter-polar axis |
B. | Rotor pole axis |
C. | In between inter polar and rotor axis |
D. | Parallel to interpolar axis |
Answer» C. In between inter polar and rotor axis | |