Explore topic-wise MCQs in Electronic Devices Circuits.

This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Electronic Devices Circuits knowledge and support exam preparation. Choose a topic below to get started.

1.

Q. What should be the gain of an amplifier at 20 kHz if the half power frequencies are fL = 20 Hz and fH = 15 kHz along with mid band gain = 80?

A. 22.76
B. 45.09
C. 40.08
D. 48.07
Answer» E.
2.

The configuration in which output impedance of transistor amplifier is highest is ___________

A. common collector
B. common base
C. common emitter
D. common collector and base
Answer» C. common emitter
3.

The configuration in which input impedance of transistor amplifier is lowest is ___________

A. common collector
B. common emitter
C. common base
D. common emitter & base
Answer» D. common emitter & base
4.

The configuration in which current gain of transistor amplifier is lowest is ___________

A. common collector
B. common base
C. common emitter
D. common emitter & base
Answer» C. common emitter
5.

THE_CONFIGURATION_IN_WHICH_INPUT_IMPEDANCE_OF_TRANSISTOR_AMPLIFIER_IS_LOWEST_IS____________?$

A. common collector
B. common emitter
C. common base
D. common emitter & base
Answer» D. common emitter & base
6.

Q. What should be the gain of an amplifier at 20 kHz if the half power frequencies are fL = 20 Hz and fH = 15 kHz along with mid band gain = 80?$

A. 22.76
B. 45.09
C. 40.08
D. 48.07
Answer» E.
7.

The configuration in which output impedance of transistor amplifier is highest is ___________$

A. common collector
B. common base
C. common emitter
D. common collector and base
Answer» C. common emitter
8.

The configuration in which current gain of transistor amplifier is lowest is __________?

A. common collector
B. common base
C. common emitter
D. common emitter & base
Answer» C. common emitter
9.

The configuration in which voltage gain of transistor amplifier is lowest is ____________

A. common collector
B. common emitter
C. common base
D. common emitter & base
Answer» B. common emitter
10.

Which capacitor is used to block DC portion by allowing to pass only AC portion of the amplified signal to load?

A. Input Coupling Capacitor
B. Bypass Capacitor
C. Output Coupling Capacitor
D. Both coupling and bypass capacitor
Answer» D. Both coupling and bypass capacitor
11.

What is the phase-shift between input and output voltages of CE amplifier?

A. 90°
B. 120°
C. 180°
D. 270°
Answer» D. 270¬¨¬®‚Äö√†√ª
12.

Which among the below assertions is not a relevant property of CE amplifier?

A. High voltage gain
B. High current gain
C. High input resistance
D. High output resistance
Answer» E.
13.

What should be the level of input resistance to allow the occurrence of source loading in common base amplifier configuration?

A. low
B. high
C. moderate
D. stale
Answer» B. high
14.

Why is the Darlington configuration not suitable for more than two transistors?

A. Because leakage current increases and voltage gain decreases with multiple numbers of transistors
B. Because leakage current decreases and voltage gain increases with multiple numbers of transistors
C. Because leakage current as well as voltage gain increases with multiple numbers of transistors
D. Because leakage current as well as voltage gain decreases with multiple numbers of transistors
Answer» B. Because leakage current decreases and voltage gain increases with multiple numbers of transistors
15.

Which type of amplifiers exhibits the current gain approximately equal to unity without any current amplification?

A. CE
B. CB
C. CC
D. Cascade
Answer» C. CC