Explore topic-wise MCQs in Computer Science Engineering (CSE).

This section includes 375 Mcqs, each offering curated multiple-choice questions to sharpen your Computer Science Engineering (CSE) knowledge and support exam preparation. Choose a topic below to get started.

1.

are used to resolve and combine multipath components.

A. equalizer
B. registers
C. rake receiver
D. frequency divider
Answer» D. frequency divider
2.

IS-95 is specified for reverse link operation in                    band.

A. 869-894 mhz
B. 849-894 mhz
C. 849-869 mhz
D. 824-849 mhz
Answer» E.
3.

of TDMA system is a measure of the percentage of transmitted data that contains information as opposed to providing overhead for the access scheme.

A. efficiency
B. figure of merit
C. signal to noise ratio
D. mean
Answer» B. figure of merit
4.

synchronization overhead is required in TDMA due to                 transmission.

A. high, burst
B. high, continuous
C. low, burst
D. no, burst
Answer» B. high, continuous
5.

Because of                transmissions in TDMA, the handoff process in

A. continuous, complex
B. continuous, simple
C. discontinuous, complex
D. discontinuous, simple
Answer» E.
6.

are utilized to allow synchronization of the receivers between different slots and frames.

A. preamble
B. data
C. guard bits
D. trail bits
Answer» D. trail bits
7.

is based on FDMA/FDD.

A. gsm
B. w-cdma
C. cordless telephone
D. amps
Answer» E.
8.

is undesired RF radiation.

A. intermodulation frequency
B. intermediate frequency
C. instantaneous frequency
D. instrumental frequency
Answer» B. intermediate frequency
9.

Frequency division multiple access (FDMA) assigns              channels to                 users.

A. individual, individual
B. many, individual
C. individual, many
D. many, many
Answer» B. many, individual
10.

The processing gain is given as              modulation scheme.

A. wss/r
B. r/wss
C. wss/2r
D. r/2wss
Answer» B. r/wss
11.

The jammer which monitors a communicator’s signal is known as

A. frequency follower jammers
B. repeat back jammers
C. frequency follower & repeat back jammers
D. none of the mentioned
Answer» D. none of the mentioned
12.

In Viterbi’s algorithm, the selected paths are regarded as

A. survivors
B. defenders
C. destroyers
D. carriers
Answer» B. defenders
13.

Pseudorandom signal                  predicted.

A. can be
B. cannot be
C. maybe
D. none of the mentioned
Answer» B. cannot be
14.

Which decoding method involves the evaluation by means of Fano’s algorithm?

A. maximum likelihood decoding
B. sequential decoding
C. maximum a priori
D. minimum mean square
Answer» C. maximum a priori
15.

In comparison to stack algorithm, Fano’s algorithm is simpler.

A. true
B. false
Answer» C.
16.

Which of the following is not an advantage of Fano’s algorithm in comparison to Viterbi’s algorithm?

A. less storage
B. large constraint length
C. error rate
D. small delays
Answer» E.
17.

Fano’s algorithm searches all the paths of trellis diagram at same time to find the most probable path.

A. true
B. false
Answer» C.
18.

From the following given tree, what is the computed codeword for ‘c’?

A. 111
B. 101
C. 110
D. 011
Answer» D. 011
19.

From the following given tree, what is the code word for the character ‘a’?

A. 011
B. 010
C. 100
D. 101
Answer» B. 010
20.

The DPSK needs                  Eb/N0 than BPSK.

A. 1db more
B. 1db less
C. 3db more
D. 3db less
Answer» B. 1db less
21.

Coherent PSK and non coherent orthogonal FSK have a difference of               in PB.

A. 1db
B. 3db
C. 4db
D. 6db
Answer» D. 6db
22.

In polybinary signalling method the present bit of binary sequence is algebraically added with              number of previous bits.

A. j
B. 2j
C. j+2
D. j-2
Answer» E.
23.

In precoding technique, the binary sequence is            with the previous precoded bit.

A. and-ed
B. or-ed
C. exor-ed
D. added
Answer» D. added
24.

From digital filter we will get the output pulse as the                of the current and the previous pulse.

A. summation
B. difference
C. product
D. ratio
Answer» B. difference
25.

As the roll off factor in raised cosine rolloff filter                      the occupied bandwidth

A. manchester
B. faraday
C. graham bell
D. nyquist
Answer» E.
26.

ISI is                  by increasing channel bandwidth.

A. maximized
B. minimized
C. zero
D. infinite
Answer» C. zero
27.

A nyquist pulse is the one which can be represented by            shaped pulse multiplied by another time function.

A. sine
B. cosine
C. sinc
D. none of the mentioned
Answer» D. none of the mentioned
28.

If each pulse of the sequence to be detected is in            shape, the pulse can be detected without ISI.

A. sine
B. cosine
C. sinc
D. none of the mentioned
Answer» D. none of the mentioned
29.

The bandwidth efficiency of an M-ary FSK signal                  with                  in M.

A. constant, increase
B. increases, increase
C. decreases, increase
D. decreases, decrease
Answer» D. decreases, decrease
30.

In comparison to M-ary PSK, M-ary QAM bandwidth efficiency is            and power efficiency is

A. identical, superior
B. less, superior
C. identical, identical
D. superior, superior
Answer» B. less, superior
31.

In QAM, the amplitude is                and phase is

A. varied, constant
B. varied, varied
C. constant, varied
D. constant, constant
Answer» C. constant, varied
32.

As the value of M                    the bandwidth efficiency

A. increases, same.
B. increases, decreases
C. increases, increases
D. decreases, same
Answer» D. decreases, same
33.

Which of the following is not a detection technique used for detection of π/4 QPSK signals?

A. baseband differential detection
B. if differential detection
C. fm discriminator detection
D. envelope detection
Answer» E.
34.

The bandwidth of OQPSK is                to QPSK.

A. identical
B. twice
C. half
D. four times
Answer» B. twice
35.

QPSK provides twice the bandwidth efficiency and                energy efficiency as compared to BPSK.

A. twice
B. half
C. same
D. four times
Answer» D. four times
36.

QPSK has                  the bandwidth efficiency of BPSK.

A. twice
B. same
C. half
D. four times
Answer» B. same
37.

In DPSK system, input signal is differentially encoded and then modulated using a                  modulator.

A. amplitude
B. frequency
C. bpsk
D. qpsk
Answer» D. qpsk
38.

In BPSK, the                  of constant amplitude carrier signal is switched between two values according to the two possible values.

A. amplitude
B. phase
C. frequency
D. angle
Answer» C. frequency
39.

The real part of an antenna’s input impedance is due to

A. swr
B. radiated signal
C. reflected signal
D. refracted signal
Answer» C. reflected signal
40.

is often called the formant of the speech signal.

A. pitch frequency
B. voice pitch
C. pole frequency
D. central frequency
Answer» D. central frequency
41.

Vocoders                      the voice at the receiver.

A. analyse
B. synthesize
C. modulate
D. evaluate
Answer» C. modulate
42.

Sample resolution for LPCM          bits per sample.

A. 8
B. 16
C. 24
D. all of the mentioned
Answer» E.
43.

Delta modulation uses            bits per sample.

A. one
B. two
C. four
D. eight
Answer» B. two
44.

If the channel is noiseless information conveyed is        and if it is useless channel information conveyed is

A. 0,0
B. 1,1
C. 0,1
D. 1,0
Answer» E.
45.

Quantization is a            process.

A. few to few mapping
B. few to many mapping
C. many to few mapping
D. many to many mapping
Answer» D. many to many mapping
46.

What is the frequency of the stereo sub carrier signal in FM broadcasting?

A. 19 khz
B. 45 khz
C. 55 khz
D. 38 khz
Answer» E.
47.

In angle modulation, signal to noise ratio before detection is a function of

A. modulation index
B. input signal to noise ratio
C. maximum frequency of the message
D. if filter bandwidth
Answer» E.
48.

PLL in FM detection stands for

A. phase locked loop
B. programmable logic loop
C. phase locked logic
D. programmable locked loop
Answer» B. programmable logic loop
49.

Frequency demodulator is a frequency to amplitude converter circuit.

A. true
B. false
Answer» B. false
50.

Frequency modulation index defines the relationship between the              and bandwidth of transmitted signal.

A. frequency of message signal
B. amplitude of message signal
C. amplitude of carrier signal
D. frequency of carrier signal
Answer» C. amplitude of carrier signal