

MCQOPTIONS
Saved Bookmarks
This section includes 159 Mcqs, each offering curated multiple-choice questions to sharpen your BITSAT knowledge and support exam preparation. Choose a topic below to get started.
151. |
Find the current through the diode in the given circuit. |
A. | 1 A |
B. | 2 A |
C. | 4 A |
D. | 3 A |
Answer» C. 4 A | |
152. |
In Varactor Diode, if reverse voltage will increase space charge width: |
A. | decrease |
B. | remains the same |
C. | increase |
D. | decrease rapidly |
Answer» D. decrease rapidly | |
153. |
A square wave of ± 20 V is given to the clamper circuit given below. What are the minimum and maximum value of the output voltage (Vout)? Assume ideal diode. |
A. | -10 V, 0 V |
B. | -20 V, +20 V |
C. | -30 V, +10 V |
D. | -10 V, +30 V |
Answer» E. | |
154. |
For Clamp circuit one must _____ |
A. | add DC signal with DC |
B. | add AC signal with DC |
C. | add AC signal with AC |
D. | subtract AC from DC |
Answer» C. add AC signal with AC | |
155. |
In the circuit given below, what is Vout? |
A. | Vm |
B. | 2 Vm |
C. | 3 Vm |
D. | 4 Vm |
Answer» E. | |
156. |
A filtered full-wave rectifier voltage has a smaller ripple than does a half-voltage for the same load resistance and capacitor values because: |
A. | there is a shorter time between peaks |
B. | there is a longer time between peaks |
C. | the larger the ripple, the batter the filtering action |
D. | none of the above |
Answer» B. there is a longer time between peaks | |
157. |
If the PIV rating of a diode is exceeded, __________. |
A. | The diode conducts poorly |
B. | The diode behaves like a tunnel diode |
C. | The diode is destroyed |
D. | The diode behaves like a capacitor |
Answer» D. The diode behaves like a capacitor | |
158. |
In the circuit shown below, the ideality factor η of the diode is unity and the voltage drop across it is 0.7 V. The dynamic resistance of the diode at room temperature is approximately. |
A. | 15 Ω |
B. | 25 Ω |
C. | 50 Ω |
D. | 700 Ω |
Answer» C. 50 Ω | |
159. |
Circuit used to shift the DC level of the input signal is: |
A. | Clamper |
B. | Rectifier |
C. | Amplifier |
D. | Clipper |
Answer» B. Rectifier | |