Which of the following is responsible for the orange-peel effect?

Isotropic nature of the material

Anisotropic nature of the material

The critical amount of cold work is the ______

maximum amount of cold work that allows recrystallization

minimum amount of cold work that allows recrystallization

maximum amount of cold work that allows recrystallization

amount of cold work need to recover the specimen

amount of cold work needed to increase the yield strength by 10 MPa

The recrystallized grain size is the crystal size immediately at the end of ______

1 hr from the start of the recrystallization

Explore topic-wise MCQs in Manufacturing Processes.

This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Processes knowledge and support exam preparation. Choose a topic below to get started.

1.	In metal that is cold-rolled, it is relatively easy to avoid a critical amount of cold work.
A.	True
B.	False
Answer» B. False

Discussion

2.	Critical deformation may exceed several hundred percent in case of deformation due to easy glide.
A.	True
B.	False
Answer» B. False

Discussion

3.	Which of the following is responsible for the orange-peel effect?
A.	Large diameter
B.	Isotropic nature of the material
C.	Anisotropic nature of the material
D.	Deformation
Answer» D. Deformation

Discussion

4.	If the diameter of the average grain is large, cold working produces _____
A.	smooth surface
B.	roughened surface
C.	highly tensed surface
D.	cracks
Answer» C. highly tensed surface

Discussion

5.	Plastic deformation occurs without roughing of the surface if the grain size of the metal is less than _____ in diameter.
A.	0.002 mm
B.	0.05 mm
C.	0.1 mm
D.	1 mm
Answer» C. 0.1 mm

Discussion

6.	The critical deformation is not dependent on ______
A.	material properties
B.	tension
C.	torsion
D.	compression
Answer» B. tension

Discussion

7.	The critical amount of cold work is the ______
A.	minimum amount of cold work that allows recrystallization
B.	maximum amount of cold work that allows recrystallization
C.	amount of cold work need to recover the specimen
D.	amount of cold work needed to increase the yield strength by 10 MPa
Answer» B. maximum amount of cold work that allows recrystallization

Discussion

8.	The grain size grows rapidly with decreasing ______
A.	temperature
B.	deformation
C.	yield strength
D.	hardness
Answer» C. yield strength

Discussion

9.	The recrystallized grain size is the crystal size immediately at the end of ______
A.	polygonization
B.	deformation
C.	recrystallization
D.	1 hr from the start of the recrystallization
Answer» D. 1 hr from the start of the recrystallization

Discussion

10.	Polygonization is essentially completed before the start of ______
A.	solidification
B.	recrystallization
C.	cooling
D.	grain growth
Answer» C. cooling

Discussion

Explore topic-wise MCQs in Manufacturing Processes.

In metal that is cold-rolled, it is relatively easy to avoid a critical amount of cold work.

Critical deformation may exceed several hundred percent in case of deformation due to easy glide.

Which of the following is responsible for the orange-peel effect?

If the diameter of the average grain is large, cold working produces _____

Plastic deformation occurs without roughing of the surface if the grain size of the metal is less than _____ in diameter.

The critical deformation is not dependent on ______

The critical amount of cold work is the ______

The grain size grows rapidly with decreasing ______

The recrystallized grain size is the crystal size immediately at the end of ______

Polygonization is essentially completed before the start of ______