Explore topic-wise MCQs in Aerospace Materials and Processes.

This section includes 12 Mcqs, each offering curated multiple-choice questions to sharpen your Aerospace Materials and Processes knowledge and support exam preparation. Choose a topic below to get started.

Explore topic-wise MCQs in Aerospace Materials and Processes.

Aircraft materials need a bending test.

A bend of what angle is considered as a single bend?

What is the rate of bending carried out for heavy wires?

The maximum rate up to which bending is done per minute is ________ in reverse bend test.

The radius to which the jaws of the vice rounded to for wires of diameter less than 3/16 inches is _________

_________ usually undergoes a reverse bend test.

The minimum length of wire that can be used in a reverse bend test is ________

It is usually very easy to obtain the exact bending radius desired in a bending test.

The usual angle through which bending should be obtained in a bending test is ________

If the specimen being tested is heavy in weight, it should have a __________ cross-section.

Specimens in the bending test are usually ________ inches long.

Bending tests are conducted to ensure that the material has enough _________