 
			 
			MCQOPTIONS
 Saved Bookmarks
				This section includes 23 Mcqs, each offering curated multiple-choice questions to sharpen your Linear Integrated Circuit knowledge and support exam preparation. Choose a topic below to get started.
| 1. | A band-pass filter can be created by cascading a high-pass filter and a low-pass filter. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 2. | An active filter uses capacitors and inductors in the feedback network. | 
| A. | True | 
| B. | False | 
| Answer» C. | |
| 3. | A Sallen-Key filter is a second-order filter. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 4. | A second-order filter has a roll-off of –20 dB/decade. | 
| A. | True | 
| B. | False | 
| Answer» C. | |
| 5. | The bandwidth of a practical high-pass filter is infinite. | 
| A. | True | 
| B. | False | 
| Answer» C. | |
| 6. | A band-pass filter passes all frequencies within a band between a lower and an upper cutoff frequency. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 7. | In filters, a single RC network is called a pole. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 8. | Butterworth filters have the characteristic of a very flat response in the passband and a roll-off of –20 dB/decade. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 9. | Filters with Bessel characteristics are used for filtering pulse waveforms. | 
| A. | True | 
| B. | False | 
| Answer» B. False | |
| 10. | The gain of the multiple-feedback band-pass filter above is equal to which of the following? Assume C = C1 = C2. | 
| A. | A0 = R2 / R1 | 
| B. | A0 = R1 / R2 | 
| C. | A0 = R2 / 2 R1 | 
| D. | A0 = R1 / 2 R2 | 
| Answer» D. A0 = R1 / 2 R2 | |
| 11. | The bandwidth of a band-pass filter is the sum of the two cutoff frequencies. | 
| A. | True | 
| B. | False | 
| Answer» C. | |
| 12. | A ________ filter significantly attenuates all frequencies below fc and passes all frequencies above fc. | 
| A. | low-pass | 
| B. | high-pass | 
| C. | band-pass | 
| D. | band-stop | 
| Answer» C. band-pass | |
| 13. | Refer to this figure. Increasing the values of the filter section resistors in this circuit will cause the fc to | 
| A. | increase. | 
| B. | decrease. | 
| C. | remain the same. | 
| D. | increase and then decrease. | 
| Answer» C. remain the same. | |
| 14. | Refer to the given figure. RA = 2.2 k and RB = 1.2 k. This filter is probably a | 
| A. | Butterworth type. | 
| B. | Bessel type. | 
| C. | Chebyshev type. | 
| Answer» B. Bessel type. | |
| 15. | Refer to the given figure. This circuit is known as a ________ filter, and the fc is ________. | 
| A. | high-pass, 1.59 kHz | 
| B. | band-pass, 15.9 kHz | 
| C. | low-pass, 15.9 kHz | 
| D. | high-pass, 15.9 kHz | 
| Answer» E. | |
| 16. | Name the filter that has two stop bands? | 
| A. | Band-pass filter | 
| B. | Low pass filter | 
| C. | High pass filter | 
| D. | Band-reject filter | 
| Answer» B. Low pass filter | |
| 17. | Determine the order of filter used, when the gain increases at the rate of 60dB/decade on the stop band. | 
| A. | Second-order low pass filter | 
| B. | Third-order High pass filter | 
| C. | First-order low pass filter | 
| D. | None of the mentioned | 
| Answer» C. First-order low pass filter | |
| 18. | Which among the following has the best stop band response? | 
| A. | Butterworth filter | 
| B. | Chebyshev filter | 
| C. | Cauer filter | 
| D. | All of the mentioned | 
| Answer» D. All of the mentioned | |
| 19. | The gain of the first order low pass filter | 
| A. | Increases at the rate 20dB/decade | 
| B. | Increases at the rate 40dB/decade | 
| C. | Decreases at the rate 20dB/decade | 
| D. | Decreases at the rate 40dB/decade | 
| Answer» D. Decreases at the rate 40dB/decade | |
| 20. | In which filter the output and input voltages are equal in amplitude for all frequencies? | 
| A. | All-pass filter | 
| B. | High pass filter | 
| C. | Low pass filter | 
| D. | All of the mentioned | 
| Answer» B. High pass filter | |
| 21. | Given the lower and higher cut-off frequency of a band-pass filter are 2.5kHz and 10kHz. Determine its bandwidth. | 
| A. | 750 Hz | 
| B. | 7500 Hz | 
| C. | 75000 Hz | 
| D. | None of the mentioned | 
| Answer» C. 75000 Hz | |
| 22. | Which filter performs exactly the opposite to the band-pass filter? | 
| A. | Band-reject filter | 
| B. | Band-stop filter | 
| C. | Band-elimination filter | 
| D. | All of the mentioned | 
| Answer» E. | |
| 23. | Which filter type is called a flat-flat filter? | 
| A. | Cauer filter | 
| B. | Butterworth filter | 
| C. | Chebyshev filter | 
| D. | Band-reject filter | 
| Answer» C. Chebyshev filter | |