Explore topic-wise MCQs in Manufacturing Processes.

This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Processes knowledge and support exam preparation. Choose a topic below to get started.

1.

Addition of hard and sharp abrasive particles into the water jet can increase the cutting ability of the jet.

A. True
B. False
Answer» B. False
Discussion
2.

What will be the mass flow rate of water, when the water pressure is 4000 bar, being issued from an orifice of diameter 0.3 mm, assuming all related coefficients to be 1?

A. 1 kg/min
B. 2.89 kg/min
C. 3.26 kg/min
D. 3.79 kg/min
Answer» E.
Discussion
3.

Assuming no losses, what will be the water jet velocity, when the water pressure is 4000 bar, being issued from an orifice of diameter 0.3 mm?

A. 212 m/s
B. 467 m/s
C. 592 m/s
D. 894 m/s
Answer» E.
Discussion
4.

For which of the following operations, abrasive water jet machining is not used?

A. Peening
B. Pocket milling
C. Mass immunization
D. Cutting hard materials
Answer» E.
Discussion
5.

Which of the following materials, is not machined using abrasive water jet machining?

A. Diamond
B. Concrete
C. Stone – Granite
D. Reinforced plastics
Answer» B. Concrete
Discussion
6.

In entrained type AWJM, abrasive water jet has a velocity of around _____ m/s.

A. 100
B. 220
C. 650
D. 800
Answer» E.
Discussion
7.

To stop the dispersion of the water jet in the atmosphere ______ is used.

A. sodium Carboxylate
B. acrylonitrile
C. long chain polymers
D. silica gel
Answer» D. silica gel
Discussion
8.

In pure WJM, commercially pure water is used.

A. True
B. False
Answer» B. False
Discussion
9.

In AJMM, water at _____ MPa is pumped.

A. 100-150
B. 200-400
C. 200-300
D. 370-500
Answer» C. 200-300
Discussion
10.

Water Jet Machining (WJM) and Abrasive Jet Micromachining (AJMM or AWJM) can be achieved using how many different approaches?

A. 10
B. 5
C. 7
D. only one approach is there
Answer» D. only one approach is there
Discussion