Which type of holes can be produced through drilling using Electro di – McqOptions

MCQOPTIONS

1.	Which type of holes can be produced through drilling using Electro discharge machining?
A.	Irregular
B.	Curved
C.	Tapered
D.	All of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

What are the recast layer thickness values obtained in ED sawing?
What are the values of finish obtained by machining work piece thorough Electro discharge sawing?
How much amount of burr is produce while machined using Electro discharge sawing?
When compared to the conventional abrasive sawing, how many times faster is the MRR?
Electro discharge sawing is an application of EDM which employs __________ as tool material.
What are the values of overcuts left behind after drilling of work piece?
What are range of diameter values obtained by drilling using EDM?
What are the values of general feed rates used for drilling in EDM?
Which type of holes can be produced through drilling using Electro discharge machining?
The dielectric fluid is flushed in thorough which part of the electrode in drilling in EDM?