Which three commands can be used to check LAN connectivity problems on – McqOptions

MCQOPTIONS

1.	Which three commands can be used to check LAN connectivity problems on a router? 1.show interfaces 2.show ip route 3.tracert 4.ping 5.dns lookups
A.	1 ,2 and 4
B.	2 and 5
C.	3 and 5
D.	None of the above
Answer» B. 2 and 5

Discussion

No Comment Found

Related MCQs

Which three commands can be used to check LAN connectivity problems on a router? 1.show interfaces 2.show ip route 3.tracert 4.ping 5.dns lookups
ou are unsuccessful in telnetting into a remote device. What could the problem be? 1.IP addresses are incorrect. 2.Access control list is filtering Telnet. 3.There is a defective serial cable. 4.The VTY password is missing.
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? 1.TFTP server software must be running on the router. 2.TFTP server software must be running on your laptop. 3.The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. 4.The laptop must be on the same subnet as the router's Ethernet interface. 5.The copy flash tftp command must be supplied the IP address of the laptop.
What information is displayed by the show hosts command? 1.Temporary DNS entries 2.The names of the routers created using the hostname command 3.The IP addresses of workstations allowed to access the router 4.Permanent name-to-address mappings created using the ip host command 5.The length of time a host has been connected to the router via Telnet
What does the command o/r 0x2142 provide?
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?