MCQOPTIONS
Bookmark
Saved Bookmarks
→
Software Defined Radio
→
Performance Management Tradeoffs
→
Which of these is not a technique used to induce s...
1.
Which of these is not a technique used to induce sharp resonance in resonators?
A.
Rigidity
B.
Bulk
C.
Acoustic
D.
Piezoelectric
Answer» B. Bulk
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
The useful dynamic range applicable for antenna, RF/IF conversion, and ADC s is given by the ratio of smallest processable signal to the smallest detectable signal.
The Nyquist criterion states that the sampling frequency of a band limited analog waveform must be at least ______ component to properly reconstruct the signal.
____ fixes the input power dynamic range such that there are no sinusoidal RF conversion artifacts in the output.
Which of the following is not a challenge to RF/IF conversion stage in military application?
Electronically Programmable Analog Components are also called as ____
10.Which of the following modulation type is incompatible with class C operation?
9.RF amplifiers tend to be ____ amplifiers.
Superconductors use ____ to maintain working temperature near _____
Superconducting analog filters can reduce noise and interference introduced by wide bandwidth of SDR architecture.
RF MEMS allows selection of ____ and ____, increasing the degree of freedom in design process.
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies