Which of these is incorrect for a Wien Bridge oscillator? – McqOptions

MCQOPTIONS

1.	Which of these is incorrect for a Wien Bridge oscillator?
A.	Low distortion
B.	Good stability at the resonant frequency
C.	Difficult to tune
D.	Based on frequency selective form of a Wheatstone bridge
Answer» D. Based on frequency selective form of a Wheatstone bridge

Discussion

No Comment Found

Related MCQs

In a Wien bridge oscillator, it is found that at the frequency ωO there is no phase shift in RF/R gain loop and the phase shift of the amplifier is also zero. Then what is the equation for the radian frequency, given R1, C1 is the series network of bridge and R2, C2 is the parallel network?
For any Wien Bridge oscillator, R1 = R2 and C1 = C2 always in the bridge, provided the phase shift through the amplifier is zero.
In the below circuit, the output frequency is 0.5 Mhz.C1 = 5nF, R4 = 40kΩ, R3 = 20kΩ. Find the value of R.
Which of these is a disadvantage of the Wien Bridge oscillator?
The following circuit is provided. R1=R2 and C1=C2.What is the correct choice for sustained oscillation?
Consider the circuit shown below.Given that R1=20kΩ, C1=2nF, R2=20kΩ, C2=2nF, find the approximate resonant frequency.
At the resonant frequency, what is the phase shift for the output in a Wien Bridge oscillator?
Which of these is incorrect for a Wien Bridge oscillator?