Which of the following types of stresses is applied during the process – McqOptions

MCQOPTIONS

1.	Which of the following types of stresses is applied during the process of rod or tube drawing?
A.	Shear
B.	Direct compressive
C.	Tensile
D.	In-direct compressive
Answer» D. In-direct compressive

Discussion

No Comment Found

Related MCQs

In rod drawing, a bearing is used which causes frictional drag on the metallic bar.
Wet drawing is a process which involves throwing water jets onto the material during the process.
In rod drawing process, intermediate annealing is required for improving the ductility of material.
WET_DRAWING_IS_A_PROCESS_WHICH_INVOLVES_THROWING_WATER_JETS_ONTO_THE_MATERIAL_DURING_THE_PROCESS.?$
In_rod_drawing,_a_bearing_is_used_which_causes_frictional_drag_on_the_metallic_bar.$
In rod drawing process, intermediate annealing is required for improving the ductility of material?
In general, no any lubrication is required during the process of rod or bar drawing.
Over drawing of the metallic rod can cause poor surface finish of the product.
In rod drawing process, the final output is coiled on a large metallic form roll.
Bar or rod drawing is a process which can be performed in a single draft.