Which of the following statement about the amplitude limiter is not va – McqOptions

MCQOPTIONS

1.	Which of the following statement about the amplitude limiter is not valid?
A.	Leak type bias must be used
B.	Output must be tuned
C.	The circuit is always biased in class
D.	, by virtue of the leak type bias
E.	When the input increases past the threshold of limiting, the gain decreases to keep the output constant
Answer» D. , by virtue of the leak type bias

Discussion

No Comment Found

Related MCQs

An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
Which of the following statement about the amplitude limiter is not valid?
An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
Statement 1 Diode is the most common device used for demodulation. Statement 2 A discriminator is a FM detector.