Which of the following is true for sine table?$ – McqOptions

MCQOPTIONS

1.	Which of the following is true for sine table?$
A.	Sine table is most convenient for the light workpieces
B.	Procedure of setting angle is not same as sine bars
C.	Table may be safely swung from 0 to 90 degrees
D.	Error caused by clamping mechanism is very large
Answer» D. Error caused by clamping mechanism is very large

Discussion

No Comment Found

Related MCQs

Which of the following is true for sine table?
As per IS 5359-1969, what is the permissible tolerance on mean diameter of the rollers in 100mm sine bars?
What is sine centre?
Which of the following is true for the given statements about sine bars?Statement 1: Grade A sine bars are less accurate than grade B.Statement 2: Grade B sine bars are accurate up to 0.01 mm/m of length.
What are the characteristics permissible tolerance flatness of upper and lower surface of 100mm sine bar I.S. 5359—1969?
WHAT_IS_SINE_CENTRE??$
Which of the following is true for sine table?$
As per IS 5359-1969, what is the permissible tolerance on mean diameter of the rollers in 100mm sine bars?$
Upto which inclination sine centres can be used?
What is the parallelism tolerance of end faces of axes of rollers in sine bar according to British Standards?