Which of the following is true about Wurster fluid system’s coating – McqOptions

MCQOPTIONS

1.	Which of the following is true about Wurster fluid system’s coating process?
A.	Inner partition has a diameter that is approximately 30% of the coating chamber’s diameter
B.	Air distribution plate has holes drilled of equal sizes all over the plate
C.	Spray nozzle is located at the center of the plate
D.	Wurster fluid bed was designed in 1850
Answer» D. Wurster fluid bed was designed in 1850

Discussion

No Comment Found

Related MCQs

Water was used as the fluid in a fluidized bed. The length of the fluidization column was 1000mm. The manometer readings were 26 cm and 24 cm. Calculate the pressure difference per length of column. Acceleration due to gravity is used as 9.8 m/s2.
Calculate the initial porosity of the bed given that the void volume is 0.8901 and the total volume is 1.1.
Which of the following happens when the gas velocity increases in fluidization?
Which of the following is false about the Huttlin – Kugel coater?
Which of the following is true about Wurster fluid system’s coating process?
Calculate the porosity of the bed when the initial bed height is 24.5 cm, the final bed height is 34.5 cm and initial porosity is 0.2036.
Which of the following parts of a fluidized system separates the product from air?
Arrange the following stages of fluidization in the increasing order of gas flow.
When does slugging occur in fluidization?
How do solids behave like fluids in fluidization?