Which of the following is not a reason why large divergence angles ar – McqOptions

MCQOPTIONS

1.	Which of the following is not a reason why large divergence angles are allowed in bell-shaped nozzles immediately behind the throat?
A.	High relative pressure
B.	Large pressure gradient
C.	Rapid expansion of the working fluid
D.	Supersonic flow
Answer» E.

Discussion

No Comment Found

Related MCQs

If for a bell-shaped nozzle, the divergence angle immediately after the throat is 40°, contour angle at the inflection point is 32° and the nozzle full-angle at its exit is 10°, determine the turn-back angle.
If the divergence angle for a conical nozzle is 30°, nozzle exit diameter is 30 cm, exit pressure is 10% more than the ambient pressure, mass flow rate is 14 kg/s and the jet exhaust velocity is 700 m/s, determine the total thrust of the engine under standard sea level operating conditions.
What is the difference between the angle at the nozzle inflection point and the angle at the exit called?
Which of the following is not a reason why large divergence angles are allowed in bell-shaped nozzles immediately behind the throat?
How does the divergence angle vary along a bell-shaped nozzle?
Which of the following is a typical optimum divergence angle for a conical nozzle?
To which of the following terms can we multiply the nozzle correction factor with?
What happens to the theoretical nozzle correction factor as the nozzle angle decreases?
What is the nozzle correction factor for a conical nozzle angle of 200?
Which of the following is not an objective of a good nozzle configuration?