Which of the following is incorrect for the gauging faces of snap gaug – McqOptions

MCQOPTIONS

1.	Which of the following is incorrect for the gauging faces of snap gauges?
A.	Parallel to each other
B.	Square to each other
C.	Gauging point and work are in same plane
D.	Work and gauging faces are at 60 degree
Answer» E.

Discussion

No Comment Found

Related MCQs

If work tolerance is less than 0.09 mm then how much wear tolerance is applied to ‘Go’ gauge?
Which of the following option is correct for the given statements about Gauge design?Statement 1: ‘No Go’ gauges should put in the condition of maximum impassability in the inspection.Statement 2: ‘Go’ plug gauge corresponds to a minimum limit.
Which deviations are provided to a new ‘Go’ plug gauge from the nominal size?
What is the use of ‘No Go’ gauges?
What is the effect of wear on the size of ‘Go’ snap gauges?
Which of the following can’t be done by ‘Go’ plug gauges?
‘Go limit’ applied to which limit condition?
If_work_tolerance_is_less_than_0.09_mm_then_how_much_wear_tolerance_is_applied_to_‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬•_gauge?$#
Which deviations are provided to a new ‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬• plug gauge from the nominal size?#
What is the use of ‚Äö√Ñ√∂‚àö√ë‚àö‚â§No Go‚Äö√Ñ√∂‚àö√ë‚àö¬• gauges?$