Which of the following can’t be done by ‘Go’ plug gauges? – McqOptions

MCQOPTIONS

1.	Which of the following can’t be done by ‘Go’ plug gauges?
A.	Ensure bore alignability
B.	Controls diameter
C.	Check straightness of hole
D.	Check degree of ovality
Answer» B. Controls diameter

Discussion

No Comment Found

Related MCQs

If work tolerance is less than 0.09 mm then how much wear tolerance is applied to ‘Go’ gauge?
Which of the following option is correct for the given statements about Gauge design?Statement 1: ‘No Go’ gauges should put in the condition of maximum impassability in the inspection.Statement 2: ‘Go’ plug gauge corresponds to a minimum limit.
Which deviations are provided to a new ‘Go’ plug gauge from the nominal size?
What is the use of ‘No Go’ gauges?
What is the effect of wear on the size of ‘Go’ snap gauges?
Which of the following can’t be done by ‘Go’ plug gauges?
‘Go limit’ applied to which limit condition?
If_work_tolerance_is_less_than_0.09_mm_then_how_much_wear_tolerance_is_applied_to_‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬•_gauge?$#
Which deviations are provided to a new ‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬• plug gauge from the nominal size?#
What is the use of ‚Äö√Ñ√∂‚àö√ë‚àö‚â§No Go‚Äö√Ñ√∂‚àö√ë‚àö¬• gauges?$