Which of the following commands will display the current IP addressing – McqOptions

MCQOPTIONS

1.	Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?1. show version2. show protocols3. show interfaces4. show controllers5. show ip interface$?
A.	1, 2 and 4
B.	2, 3 and 5
C.	3 and 4 only
D.	None of the above
Answer» C. 3 and 4 only

Discussion

No Comment Found

Related MCQs

What is the problem with an interface if you type show interface serial 0 and receive the following message?"Serial0 is administratively down, line protocol is down."%!
If you delete the contents of NVRAM and reboot the router, what mode will you be in?%!
You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?%!
Which command will show you whether a DTE or a DCE cable is plugged into serial 0?%!
*$_You set the console password, but when you display the configuration, the password doesn't show up; it looks like this:[output cut]Line console 0 Exec-timeout 1 44 Password 7098C0BQR Login[output cut]What cause the password to be stored like this??
*$_What keystroke will terminate setup mode??
*/*_What layer of the OSI model would you assume the problem is in if you type show interface serial 1 and receive the following message? "Serial1 is down, line protocol is down."?
_ How many simultaneous Telnet sessions does a Cisco router support by default?$?
_ Which command will delete the contents of NVRAM on a router?$?
_ You type show running-config and get this output:[output cut]Line console 0 Exec-timeout 1 35 Password BIXPASSWD Login[output cut]What do the two numbers following the exec-timeout command mean?$?