Which command loads a new version of the Cisco IOS into a router?? – McqOptions

MCQOPTIONS

1.	Which command loads a new version of the Cisco IOS into a router??
A.	copy flash ftp
B.	copy ftp flash
C.	copy flash tftp
D.	copy tftp flash
Answer» E.

Discussion

No Comment Found

Related MCQs

*$_You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be??
*$_You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be??
*$_You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in??
*$_If you want to have more than one Telnet session open at the same time, what keystroke combination would you use??
%_A network administrator wants to upgrade the IOS of a router without removing the image currently installed. What command will display the amount of memory consumed by the current IOS image and indicate whether there is enough room available to hold both the current and new images?_%
%_What does the command o/r 0x2142 provide?_%
%_The configuration register setting of 0x2102 provides what function to a router?_%
%_Which three commands can be used to check LAN connectivity problems on a router?1. show interfaces2. show ip route3. tracert4. ping5. dns lookups_%
__You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?__
__You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?__