Which command is used to determine if an IP access list is enabled on – McqOptions

MCQOPTIONS

1.	Which command is used to determine if an IP access list is enabled on a particular interface?
A.	show access-lists
B.	show interface
C.	show ip interface
D.	show interface access-lists
Answer» D. show interface access-lists

Discussion

No Comment Found

Related MCQs

What does the command provide to dynamic routing protocols?
What does the command allow you to perform next?
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does eachhost have to the server?
What are the two main types of access control lists (ACLs)?1. Standard2. IEEE3. Extended4. Specialized
What does the commandrouterA (config) #line cons 0allow you to perform next?
What protocols are used to configure trunking on a switch?1. VLAN Trunking Protocol2. VLAN3. 802.1Q4. ISL
If your router is facilitating a CSU/DSU, which of the following commands do you need to use to provide the router with a 64000bps serial link?
What PPP protocol provides dynamic addressing, authentication, and multilink?
What is a stub network?
Which class of IP address has the most host addresses available by default?