When we want to have extremely small pressure drop for the shell side – McqOptions

MCQOPTIONS

1.	When we want to have extremely small pressure drop for the shell side and also desire to provide support to the tubes, which one the following setup should we use?
A.	Segmental Baffles
B.	Doughnut Baffles
C.	Orifice Baffles
D.	Support Plates
Answer» E.

Discussion

No Comment Found

Related MCQs

What is the maximum baffle spacing for a Shell and Tube Heat Exchanger?
What is the minimum baffle spacing for a Shell and Tube Heat Exchanger?
What is term S in the formula for Return Loss for tubes in a Shell and Tube Heat Exchanger?<br>H = ( frac{4N}{S} frac{V^2}{2g} ).
The more the number of shell and tube passes, less is the value of Correction Factor.
When we want to have extremely small pressure drop for the shell side and also desire to provide support to the tubes, which one the following setup should we use?
When steam is used on the tube side of the Heat Exchanger, then the allowable pressure drop should be less than _____ P.S.I.
Which one of the following formula is correct for return losses?
A heat exchanger was required to cool a liquid from 150 to 110 , but the outlet temperature was increased by 3 every month for same heat transfer. What should have been the fouling factor if U<sub>D</sub> = 80?
Which one of the following dirt factor should we assign to the HE for two moderately clean streams?