When a router is connected to a Frame Relay WAN link using a serial DT – McqOptions

MCQOPTIONS

1.	When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
A.	Supplied by the CSU/DSU
B.	By the far end router
C.	By the
D.	command
E.	By the Physical layer bit stream timing
Answer» B. By the far end router

Discussion

No Comment Found

Related MCQs

<p>Which encapsulations can be configured on a serial interface?</p> <p>1.Ethernet</p> <p>2.Token Ring</p> <p>3.HDLC</p> <p>4.Frame Relay</p> <p>5.PPP</p>
<p>Which WAN encapsulations can be configured on an asynchronous serial connection?</p> <p>1.PPP</p> <p>2.ATM</p> <p>3.HDLC</p> <p>4.SDLC</p> <p>5.Frame Relay</p>
<p>When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?</p>
<p>Which of the following command options are displayed when you use the <em>Router# show frame-relay ?</em> command?</p> <p><em>1.dlci</em></p> <p><em>2.neighbors</em></p> <p><em>3.lmi</em></p> <p><em>4.pvc</em></p> <p><em>5.map</em></p>