When a router is connected to a Frame Relay WAN link using a serial DT – McqOptions

MCQOPTIONS

1.	When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
A.	Supplied by the CSU/DSU
B.	By the far end router
C.	By the clock rate command
D.	By the Physical layer bit stream timing
Answer» B. By the far end router

Discussion

No Comment Found

Related MCQs

Which of the following command options are displayed when you use the command?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?1. dlci2. neighbors3. lmi4. pvc5. map
Which of the following encapsulates PPP frames in Ethernet frames and uses common PPP features like authentication, encryption, and compression?
Which of the following uses ATM as the Data Link layer protocol that's terminated at what's known as the DSLAM?
Suppose that you have a customer who has a central HQ and six branch offices. They anticipate adding six more branches in the near future. They wish to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQ router. Which of the following would you recommend?
A default Frame Relay WAN is classified as what type of physical network?
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
Which of the following describes an industry-wide standard suite of protocols and algorithms that allows for secure data transmission over an IP-based network that functions at the layer 3 Network layer of the OSI model?
In which of the following technologies is the term HFC used?
Which of the following command options are displayed when you use the Router# show frame-relay ? command? dlci neighbors lmi pvc map