WHAT_IS_THE_PERMISSIBLE_ERROR_FOR_INTERNAL_TAPER_FOR_TRUE_RUNNING_NEAR – McqOptions

MCQOPTIONS

1.	WHAT_IS_THE_PERMISSIBLE_ERROR_FOR_INTERNAL_TAPER_FOR_TRUE_RUNNING_NEAREST_TO_SPINDLE_NOSE??$
A.	0.02mm ‚Äö√Ñ√∂‚àö√ë‚àö¬® 0.045mm 0.04 mm
B.	0.01mm ‚Äö√Ñ√∂‚àö√ë‚àö¬® 0.025mm 0.03 mm
C.	0.1mm ‚Äö√Ñ√∂‚àö√ë‚àö¬® 0.25mm 0.02 mm
D.	0.0mm ‚Äö√Ñ√∂‚àö√ë‚àö¬® 0.025mm 0.01 mm
Answer» C. 0.1mm ‚Äö√Ñ√∂‚àö√ë‚àö¬® 0.25mm 0.02 mm

Discussion

No Comment Found

Related MCQs

What is the permissible error for internal taper for true running nearest to spindle nose?
Which of the following option is true for given statements about alignment test on a milling machine?Statement 1: Heavy cast iron standards are always rigid sand solid enough to withstand stresses.Statement 2: Each trial measurement of machines is based on its correct erection.
WHAT_IS_THE_PERMISSIBLE_ERROR_FOR_INTERNAL_TAPER_FOR_TRUE_RUNNING_NEAREST_TO_SPINDLE_NOSE??$
At how many points the axial slip is tested on the collar of the spindle?
What is the length of the bracket which is used for checking the parallelism of centre slot with the longitudinal movement of the table?
Which of the following is not true about the testing of eccentricity of external diameter?
What is the error caused when transverse movement is not parallel with spindle axis on milling machine?
What is the length of mandrel which is used to test true running of internal taper on milling machine?
What is another name of the axial play?
What is the load condition when a relative alignment of machine parts and accuracy of control devices measured?