What is the machinability rate of glass by USM? – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Advanced Machining
→ Entrance Exams in Advanced Machining
→ What is the machinability rate of glass by USM?..

1.	What is the machinability rate of glass by USM?
A.	25%
B.	50%
C.	75%
D.	100%
Answer» E.

Discussion

No Comment Found

Related MCQs

The machinability of USM depends on brittleness criterion.
In the following mechanisms, which one is dominant in material removal?
What is the machinability rate of glass by USM?
Which of the following are the features of tool affecting MRR in USM?
The rate of material removal depends on which of the following features?
When machining porous material, which type of mechanism is introduces?
The following mechanisms, which one is dominant in material removal?
What is the percentage of contribution of cavitation to the total material removed?
By which of the following means, material is removed in USM?

Related Topics

Entrance Exams in Advanced Machining

Laser Beam Machining Introduction in Advanced Machining

Edm Surface Integrity in Advanced Machining

Abrasive Water Jet Machining Introduction in Advanced Machining

Edm Process Control Automation Environmental Impact in Advanced Machining

Ecm Process Characteristics in Advanced Machining

Chm Limitations in Advanced Machining

Electro Discharge Machining Introduction in Advanced Machining

Usm Machining System in Advanced Machining

Chemical Milling Introduction in Advanced Machining

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com