What is the error in overall dimension when a pair of jaws wrung toget – McqOptions

MCQOPTIONS

1.	What is the error in overall dimension when a pair of jaws wrung together?
A.	Should not exceed ¬¨¬®¬¨¬± 0.0007 mm
B.	Less than ¬¨¬®¬¨¬± 0.0001 mm
C.	Should not exceed ¬¨¬®¬¨¬± 0.0001 mm
D.	Should not exceed ¬¨¬®¬¨¬± 0.001 mm
Answer» D. Should not exceed ¬¨¬®¬¨¬± 0.001 mm

Discussion

No Comment Found

Related MCQs

Which of the following is incorrect about slip gauge accessories?
What is the value of flatness for the surface upon which slip gauges are wrung?
Which of the following option is correct for given statements?Statement 1: Slip gauge and its accessories can be used as a limit gauge.Statement 2: Slip gauge and accessories can be used for the measurement of plug gauge but not for ring gauges.
Which of the option is correct for given statements about measuring jaws types?Statement 1: Nominal sizes of measuring jaws are engraved on front end face.Statement 2: In Type B measuring jaws, no dimension is important.
WHAT_IS_THE_VALUE_OF_FLATNESS_FOR_THE_SURFACE_UPON_WHICH_SLIP_GAUGES_ARE_WRUNG??$
Which_of_the_following_is_incorrect_about_slip_gauge_accessories?$
What is the value of hardness for slip gauge accessories?
How much deviation in height of base is acceptable from marked dimension?
Which of the following is the range in which holder is available?
What is the error in overall dimension when a pair of jaws wrung together?