What is connected between the antenna and the mixer to avoid oscillat – McqOptions

MCQOPTIONS

1.	What is connected between the antenna and the mixer to avoid oscillator radiation?
A.	LNA
B.	Attenuator
C.	Duplexer
D.	Power amplifier
Answer» B. Attenuator

Discussion

No Comment Found

Related MCQs

What type of oscillators are used to input a wide range of frequencies to the IF amplifier?
The LNA of a transducer has failed during the transmission of a signal. Which component’s failure has caused this?
Which of the following is not an advantage of using RF amplifiers in the initial stage of signal selection?
What is connected between the antenna and the mixer to avoid oscillator radiation?
Analog signals : Signal to noise ratio:: Digital signals _________
WHAT_IS_CONNECTED_BETWEEN_THE_ANTENNA_AND_THE_MIXER_TO_AVOID_OSCILLATOR_RADIATION??$
The LNA of a transducer has failed during the transmission of a signal. Which component‚Äö√Ñ√∂‚àö√ë‚àö¬•s failure has caused this?$#
Which_of_the_following_is_not_an_advantage_of_using_RF_amplifiers_in_the_initial_stage_of_signal_selection?$
What_type_of_oscillators_are_used_to_input_a_wide_range_of_frequencies_to_the_IF_amplifier?
What is the output of a mixer circuit?