What is A, B, C and D to design a voltage doubler in the given circui – McqOptions

MCQOPTIONS

1.	What is A, B, C and D to design a voltage doubler in the given circuit?
A.	A=B=Resistors, C=D=Diodes
B.	A=D=Capacitors, B=C=Diodes
C.	A=Capacitor, B=D=Diodes, C=Resistor
D.	A=C=Diodes, B=D=Capacitors
Answer» C. A=Capacitor, B=D=Diodes, C=Resistor

Discussion

No Comment Found

Related MCQs

Consider the circuit shown. The input is a square wave ± 15 V, for a silicon diode and an output voltage swing of 30 V. Choose the validity of the statement. If the value of resistance R = 10KΩ and capacitance C = 1MF.
Choose the correct option for the relation between the two circuits.a) Circuit (a) is a voltage doubler circuit, while Circuit (b) does not double the voltageb) Both are similar and double the voltage to 2Vmc) Circuit (a) is a doubler circuit with output +2Vm and Circuit (b) is a doubler with output -2Vmd) Circuit (
Tilt of output waveform for the circuit is 1%. Given that input is a square wave ± 10 V, f = 2 kHz, diode cut-in voltage = 0.7, what is the relation between C and R?
Considering a clamper circuit, where capacitance C, load R, the cut-in voltage of diode are unknown, which is the correct statement?
In the given circuit, given that C=2MF and diode cut-in voltage, Vγ =0. Calculate the average output voltage.
Given input for the circuit is f = 1 KHz.Diode cut-in voltage = 0.7 VOutput waveform:For the given output, find V1 and discharge time?
Consider the circuit provided. Total discharge time = 0.5 ms. Consider the diode to be an ideal diode, for a square wave input of ± 10 V, what is the percentage tilt? (C = 1MF & R = 50k Ohms)
What is A, B, C and D to design a voltage doubler in the given circuit?
Which of the following is not true regarding clamper?