_ What does the passive command provide to dynamic routing protocols?$ – McqOptions

MCQOPTIONS

1.	_ What does the passive command provide to dynamic routing protocols?$?
A.	Stops an interface from sending or receiving periodic dynamic updates.
B.	Stops an interface from sending periodic dynamic updates but not from receiving updates.
C.	Stops the router from receiving any dynamic updates.
D.	Stops the router from sending any dynamic updates.
Answer» C. Stops the router from receiving any dynamic updates.

Discussion

No Comment Found

Related MCQs

What protocols are used to configure trunking on a switch?1. VLAN Trunking Protocol2. VLAN3. 802.1Q4. ISL%!
If you wanted to delete the configuration stored in NVRAM, what would you type?%!
Which command is used to upgrade an IOS on a Cisco router?%!
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?%!
*/*_You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server??
*/*_Which protocol is used to send a destination network unknown message back to originating hosts??
*/*_Which of the following commands will allow you to set your Telnet password on a Cisco router??
*/*_Which one of the following is true regarding VLANs??
*/*_Which class of IP address has the most host addresses available by default??
*/*_Which protocol does Ping use??