What does ‘A’ represent in the diagram? – McqOptions

MCQOPTIONS

1.	What does ‘A’ represent in the diagram?
A.	Stress meter
B.	Radius
C.	Gage length
D.	Diameter of center
Answer» E.

Discussion

No Comment Found

Related MCQs

The elongation of a material can be obtained through tension testing.
A materials proof stress is also referred to as ___________
The proof stress of a material of 3 inches gage length is the highest stress it can withstand without a permanent set of above ___________ inch.
Why must an accurate extensometer be used in reading a permanent set?
A materials proof stress is the highest stress possible for it to tolerate without causing a permanent set of more than ___________ inch per inch the length of gage, after the total release of stress.
What does ‘A’ represent in the diagram?
For a 4-inch gage length, crosshead speed of a machine should not exceed ___________ inch up to yield point.
It is possible to determine the proof stress in a way in which ___________ is determined.
The tension testing machine (crosshead) should not cross a speed of ___________ inch per inch of the gage length per minute until the yield point.
In the tension testing experiment, while determining elastic limit, the increment, while the load is being increased, should not exceed ___________ % of the elastic limit in the ending.