What command do you type to save the configuration stored in RAM to NV – McqOptions

MCQOPTIONS

1.	What command do you type to save the configuration stored in RAM to NVRAM?
A.	Router(config)#copy current to starting
B.	Router#copy starting to running
C.	Router(config)#copy running-config startup-config
D.	Router#copy run startup
Answer» E.

Discussion

No Comment Found

Related MCQs

You type and get this output: What do the two numbers following the exec-timeout command mean?
What layer of the OSI model would you assume the problem is in if you type and receive the following message?
What is the problem with an interface if you type and receive the following message?
You type the following command into the router and receive the following output: Why was this error message displayed?
You type show running-config and get this output:[output cut]Line console 0Exec-timeout 1 35Password BIXPASSWDLogin[output cut]What do the two numbers following the exec-timeout command mean?
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?1. show version2. show protocols3. show interfaces4. show controllers5. show ip interface
You type the following command into the router and receive the following output:Router#show serial 0/0^% Invalid input detected at '^' marker.Why was this error message displayed?
What is the problem with an interface if you type show interface serial 0 and receive the following message?"Serial0 is administratively down, line protocol is down."
You set the console password, but when you display the configuration, the password doesn't show up; it looks like this:[output cut]Line console 0Exec-timeout 1 44Password 7098C0BQRLogin[output cut]What cause the password to be stored like this?
What keystroke will terminate setup mode?