What are reasons for creating OSPF in a hierarchical design? To decrease routing overhead To speed up convergence To confine network instability to single areas of the network To make configuring OSPF easier

What are reasons for creating OSPF in a hierarchical design? To decr

1.	What are reasons for creating OSPF in a hierarchical design? To decrease routing overhead To speed up convergence To confine network instability to single areas of the network To make configuring OSPF easier
A.	1, 2 and 3
B.	3 only
C.	3 and 4
D.	2, 3 nd 4
Answer» B. 3 only

Discussion

No Comment Found

Related MCQs

You get a call from a network administrator who tells you that he typed the following into his router: He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?
You get a call from a network administrator who tells you that he typed the following into his router:Router (config) #router ospf 1Router (config-router) #network 10.0.0.0 255.0.0.0 area 0He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?
Which of the following protocols support VLSM, summarization, and discontiguous networking?1. RIPv12. IGRP3. EIGRP4. OSPF5. BGP6. RIPv2
Which two of the following commands will place network 10.2.3.0/24 into area 0?1. router eigrp 102. router ospf 103. network 10.0.0.04. network 10.2.3.0 0.0.0.255 area05. network 10.2.3.0 0.0.0.255 area 0
Which type of OSPF network will elect a backup designated router?1. Broadcast multi-access2. Non-broadcast multi-access3. Point-to-point4. Broadcast multipoint
Which of the following network types have a designated router and a backup designated router assigned?1. Broadcast2. Point-to-point3. NBMA4. NBMA point-to-point
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
Which of the following protocols support VLSM, summarization, and discontiguous networking? RIPv1 IGRP EIGRP OSPF BGP RIPv2
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?
Which type of OSPF network will elect a backup designated router? Broadcast multi-access Non-broadcast multi-access Point-to-point Broadcast multipoint

What are reasons for creating OSPF in a hierarchical design? To decrease routing overhead To speed up convergence To confine network instability to single areas of the network To make configuring OSPF easier

Discussion

No Comment Found

Related MCQs

Reply to Comment