Tolerance for a shaft of 50mm diameter as the basic size, with the fun – McqOptions

MCQOPTIONS

1.	Tolerance for a shaft of 50mm diameter as the basic size, with the fundamental deviation denoted by g and tolerance of grade 7 is represented as?
A.	g50,7
B.	50g7
C.	7g50
D.	None of the mentioned
Answer» C. 7g50

Discussion

No Comment Found

Related MCQs

Hot rolled components have better toughness and ductility.
Hot working or cold working, which reduces strain hardening and residual stresses.
The temperature at which new stress free grains are formed in the metal is called the ______ temperature.
Tolerance for a shaft of 50mm diameter as the basic size, with the fundamental deviation denoted by g and tolerance of grade 7 is represented as?
How many grades of tolerances are there according to BIS system fits and tolerances?
Which of the following are true for fundamental deviation?
The description of tolerances consists of two parts namely?
Which of the following are true for system of tolerances to the shaft and the hole?
In this case, tolerance zone of hole is entirely below that of the shaft.
Which of the following always provides a positive clearance between the hole and the shaft over the entire range of tolerances?